In order to promote the engineering application of indirect evaporative cooling (IEC) in the field of building air conditioning, as well as reduce air conditioning energy consumption and carbon emissions, this paper proposes a fresh air unit using indirect evaporative cooling to achieve heat recovery from exhaust air, which gives the recommended values of air and spray water operation parameters. The indirect evaporative cooler heat and mass transfer mathematical model and numerical solution procedure were made. In summer outdoor design conditions, the fresh air outlet state parameters, cooling capacity, fresh air cooling load, wet bulb efficiency and enthalpy efficiency were numerically solved for thirty typical cities from five climate zones of China. In addition, also based on the model results for the cities in China, two representative operating conditions points of medium and high humidity were selected. Eight models of fresh air unit coolers in the air volume range of 1000–10,000 m3/h commonly used in engineering were simulated to obtain the optimal heat transfer area and size selection of ERIEC heat exchangers for fresh air units, and economic analysis was performed. The results show that the wet bulb efficiency ranges from 0.67–0.98, and increases as the outdoor design wet bulb temperature decreases; the enthalpy efficiency ranges from 0.76–1.29, and increases as the outdoor design wet bulb temperature increases; and the fresh air load that the exhaust air heat recovery type indirect evaporative cooler can bear ranges from 55–100%, which could largely decrease the cold load of the matched surface cooler. As demonstrated, the energy-saving effect is remarkable.
14 March 2018 in Science and Technology for the Built Environment
A comparison of the results obtained from typical collection efficiency models of fibrous media to experimental values has been done in the current article. To predict the pressure drop of air across the filter more accurately, a new relationship of the nondimensional force is proposed in the consideration of slip flow and actual geometry of the filter. Then, the filtration performance for different structural and operating parameters is evaluated with a comprehensive index as the criterion, and the higher the values of comprehensive index, the better the filter performance. The results show that relative to the collection efficiency, the interference effects of fibers and the superficial velocity play more significant roles in the pressure drop. The lower the values of fiber volume fraction and velocity, the higher the value of comprehensive index. Similar-shaped curves that reflect the effect of velocity on the comprehensive index can be expected for different fiber diameters, but, in view of the different dominant capture mechanism at different velocities, they are not identical. At lower velocities, the larger the fiber diameter, the higher the value of comprehensive index. However, at higher velocities, the smaller the fiber diameter, the higher the value of comprehensive index.
21 February 2018 in IOP Conference Series: Earth and Environmental Science
A comparison of the results obtained from typical pressure drop models of fibrous media to experimental values has been done in the paper. Then, the pressure drop characteristics for different structural and operating parameters would be evaluated. The results show that Davies model instead of Kuwabara, Henry and Happel models fits well with the tested data and gives errors of less than 7.0%. Pressure drop across the media increases with increasing solid fraction, superficial velocity and fibre layer thickness, and decreases with increasing fibre diameter. Fibre diameter in the range of smaller values and solid fraction have more significant effects on the air flow resistance than the other factors.
19 July 2026 in International Journal of Optomechatronics
1. The global floriculture industry has shown dynamic growth in recent decades, and its export earnings have reached up to 42.2 billion dollars.[1] Given the significant economic contribution of th...