Growth of smooth and continuous films of WSe 2 has been demonstrated by employing atomic layer deposition (ALD) on 5 cm × 5 cm substrates. The substrates consisted of silicon wafers with a layer of SiO 2 . The ALD precursors were WCl 5 and H 2 Se. The film properties characterized using Raman spectroscopy and x-ray photoelectron spectroscopy are comparable to those reported for WSe 2 films produced by chemical vapor deposition and exfoliation. Carrier mobilities were determined with back-gated transistors. With Pd contacts, median electron and hole mobilities of 531 cm 2 V −1 s −1 and 354 cm 2 V −1 s −1 , respectively, were measured.
MoP is a topological semimetal which has drawn attention due to its unique electrical and optical properties resulting from massless electrons. In order to utilize these properties for practical applications, it is necessary to develop a technique to produce high-quality, large-scale thin films of this 2D material. We report below our initial results of growth of MoP thin films using atomic layer deposition (ALD), where the film grows layer-by-layer. These films were grown on 5 cm × 5 cm silicon oxide coated Si wafers. Resistivity versus temperature measurements show that these films are metallic and includes a partial superconducting phase. The magnetoresistances of both the longitudinal and Hall currents measured at 1.8 K show a strong effect of the magnetic field on the resistivity. Density functional theory was employed to determine the lattice constants of the MoP crystal. These parameters were in good agreement with those obtained from the Rietveld fit to the XRD spectrum of the films.
19 September 2018 in Semiconductor Science and Technology
We have employed first-principles density functional calculations using Quantum ESPRESSO software to study the carrier conductance in few-layer thick 2D WSe 2 semiconducting films. The results of this simulation are then compared to the experimental results where the films were grown via atomic layer deposition. The contact resistances were determined using the transfer line method. A comparison of experimental and simulated carrier conductance values shows a good agreement.