German Giacoman Vallejos

Dr. German Giacoman Vallejos

orcid

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2017 in Chemosphere
Verified
Journal Article
Closed access
LALorenzo-Flores Alfonso
Lorenzo-Flores Alfonso
GVGerman Giacoman Vallejos
German Giacoman Vallejos
MPMaría del Carmen Ponce-Caballero
María del Carmen Ponce-Caballero
HGHossein Ghoveisi
Hossein Ghoveisi

27 January 2021 in Materials
Verified
Journal Article
Open access
PDF file
IRINES RIECH
INES RIECH
CCCarlos Castro-Montalvo
Carlos Castro-Montalvo
LWLoïs Wittersheim
Loïs Wittersheim
GVGerman Giacoman Vallejos
German Giacoman Vallejos
AGAvel González
Avel González
Jose Mendez-GamboaJose Mendez-Gamboa
Jose Mendez-Gamboa
As the use of photovoltaic installations becomes extensive, it is necessary to look for recycling processes that mitigate the environmental impact of damaged or end-of-life photovoltaic panels. There is no single path for recycling silicon panels, some works focus on recovering the reusable silicon wafers, others recover the silicon and metals contained in the panel. In the last few years, silicon solar cells are thinner, and it becomes more difficult to separate them from the glass, so the trend is towards the recovery of silicon. In this paper, we investigate the experimental conditions to delaminate and recovery silicon in the recycling process, using a combination of mechanical, thermal, and chemical methods. The conditions of thermal treatment to remove the ethylene-vinyl acetate (EVA) layer were optimized to 30 min at 650 °C in the furnace. To separate silicon and metals, the composition of HF/HNO3 solution and the immersion time were adjusted considering environmental aspects and cost. Under the selected conditions, panels from different manufacturers were tested, obtaining similar yields of recovered silicon but differences in the metal concentrations.

21 September 2024 in Chemical Engineering Journal
Verified
Journal Article
Open access
Youness ABDELLAOUIYouness ABDELLAOUI
Youness ABDELLAOUI
BIBrahim El Ibrahimi
Brahim El Ibrahimi
MAMohammadi Ahrouch
Mohammadi Ahrouch
ZKzineb kassab
zineb kassab
RBRachid El Kaim Billah
Rachid El Kaim Billah
PGPrócoro Gamero
Prócoro Gamero

13 June 2019 in Applied Sciences
Verified
Journal Article
Open access
PDF file
MAMohamed Abatal
Mohamed Abatal
AQAtl V. Córdova Quiroz
Atl V. Córdova Quiroz
MOMaría Teresa Olguín
María Teresa Olguín
AVAmérica R. Vázquez-Olmos
América R. Vázquez-Olmos
Joel VargasJoel Vargas
Joel Vargas
GVGerman Giacoman Vallejos
German Giacoman Vallejos
The removal of Pb(II) from aqueous solutions by acid-modified clinoptilolite-rich tuff was investigated in this work. Clinoptilolite-rich tuff samples were treated using H2SO4 at different concentrations. Prior to and following acid treatment, the samples were characterized using X-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS), and Fourier-transform infrared spectroscopy (FTIR). The pH of the point of zero charge (pHPZC) was also determined as part of this characterization. Batch studies were studied to investigate Pb(II) removal as a function of contact time, initial Pb(II) concentration, adsorbent dosage, and solution pH. The results of the XRD and SEM techniques showed that clinoptilolite is the main mineral of the non- and acid-treated natural zeolite samples. However, EDS analysis indicated that the Si/Al ratio increases as the exchangeable ions decrease with increasing acid concentrations. The optimum conditions for Pb(II) removal for samples with 4.37 ≤ Si/Al ≤ 7.9 were found to be as follows: Contact time of 60–360 min, pH: 6–8, and adsorbent dose of 6 mg g−1; whereas for acid-modified clinoptilolite-rich tuffs with 9.01 ≤ Si/Al ≤ 9.52, these conditions were as follows: Contact time of 1440 min, pH: 8–10, and adsorbent dose of 10 mg g−1. The experimental data were analyzed by kinetic and isotherms models. The results showed that the sorption of Pb(II) on samples with Si/Al ratios of 4.37, 5.31, and 7.91 were in agreement with the pseudo-second order and Langmuir isotherm with qm = 48.54, 37.04, and 14.99 mg g−1, respectively, while the kinetic data and isotherm for samples with 9.01 ≤ Si/Al ≤ 9.52 were found to fit the pseudo-first order and Freundlich model.

14 May 2025 in International Journal of Hydrogen Energy
Verified
Journal Article
Closed access
JÁJorge E. Álvarez-Ley
Jorge E. Álvarez-Ley
RMRoger I. Méndez-Novelo
Roger I. Méndez-Novelo
GVGerman Giacoman Vallejos
German Giacoman Vallejos
LSLaura A. Paniagua Solar
Laura A. Paniagua Solar
LPLILIANA SAN PEDRO
LILIANA SAN PEDRO

2 November 2020 in Bulletin of Environmental Contamination and Toxicology
Verified
Journal Article
Closed access
PDF file
YAYouness Abdellaoui
Youness Abdellaoui
PGPrócoro Gamero-Melo
Prócoro Gamero-Melo
LOURDES DIAZ JIMENEZLOURDES DIAZ JIMENEZ
LOURDES DIAZ JIMENEZ
CPCarmen Ponce-Caballero
Carmen Ponce-Caballero
GVGerman Giacoman Vallejos
German Giacoman Vallejos