Understanding the dynamics of a droplet impinging on a liquid pool and the associated phenomena have been of interest due to its prevalence in nature as well as in technical applications. This paper aims toward studying the characteristics of the capillary waves generated due to the low Weber number droplet interactions with the liquid pool. In this direction, experiments have been carried out for six different pool heights varying from h =1.4 to 12 mm, encompassing thin liquid film, shallow pool, and deep pool regimes. Due to its wide usage, water has been chosen as the fluid of interest for droplet as well as for pool liquid. The study is focused on droplets impinging on the liquid pool at low Weber number ranging from 1 to 100. In order to characterize the post-impact perturbations in the liquid, background oriented schlieren (BOS) technique has been employed which offers real-time, non-intrusive whole-field measurements of the perturbations in the liquid pool. Measurements from BOS have been validated against the side-view projection of the impact. The transient variations of the air–water interface for different pool regimes and Weber numbers have been delineated. Results evince the formation of secondary wave at impact followed by the formation of primary wave after the crater retraction. The wave formation was faster and had higher amplitude in thin liquid regime for droplets with the same Weber number compared to the other regimes, but the perturbations were reduced through higher dissipation. The formation of the Worthington jet was seen in shallow and deep pool regimes for droplets with higher Weber number (We =100), and its effect on the capillary wave is also discussed.
Interfacial dynamics resulting from a heating source located near the interface play a crucial role in dictating the heat and momentum transport in the near-interface region. This paper aims toward simultaneous characterization of interfacial deformation and thermal behavior under the action of a line heating source placed below the interface. Experiments have been conducted on aqueous glycerol with a heating wire at different power inputs and depths from the interface. The interfacial deformations are mapped and quantified by employing moon-glade background oriented schlieren, which offers real-time, non-intrusive whole field measurements based on the deflection of light rays from liquid interface. Infrared thermography is used to measure transient interfacial temperature variations. Results show that the interface exhibits a convex-shaped deformation under the influence of the heating wire for all cases of heating power and depth. The maximum interface temperature coincides with the peak interfacial deformation. However, the region of thermal influence is smaller compared to the deformed region. Non-dimensionalization of transient interface deformation and temperature profiles establishes the underlying similarity of the phenomenon as non-dimensional interface perturbation profiles overlap for all cases of height and heating power. These characteristics are also observed for normalized temperature profiles at different wire depths.
18 February 2025 in Journal of Thermal Science and Engineering Applications
We report the dynamics and heat transfer characteristics of water droplets impacting a thin stainless-steel foil maintained at different temperatures. The hydrophobic characteristics are imparted to the surface through polysiloxane coating, and water droplets impact the uncoated and coated heated surfaces at different velocities. High-speed videography is utilized to capture the dynamics of the droplet upon impact, while the temperature field of the substrate, during the phenomenon, is simultaneously recorded using high-speed infrared thermography. Heat transfer to the droplet over different surfaces is determined through energy balance on the foil using the captured thermographs. The results reveal that the spreading phase duration is independent of droplet impact velocity, irrespective of surface wettability, whereas surface wettability primarily affects the receding phase. The coated hydrophobic surfaces exhibited lower resistance to motion at the three-phase contact line, resulting in reduced spread ratios during the receding phase. It is noted that the majority of heat transfer occurred during the initial spreading and receding phases, driven primarily by forced convection. The maximum heat fluxes were observed along the three-phase contact line, particularly at the onset of the receding phase. The coated surface demonstrated lower overall heat transfer rates compared to non-coated surfaces, with the difference increasing at higher surface temperatures. Additionally, an increase in surface temperature to 75 °C enhanced the hydrophobicity of the coated surface, leading to prolonged receding phases and extended time to reach the sessile state.