Jaywant H. Arakeri

Jaywant H. Arakeri

Auto-generated profile, based on publicly available information

Jaywant H. Arakeri

Department of Mechanical Engineering, Indian Institute of Science, Bangalore, India

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 April 2025 in International Journal of Multiphase Flow
Verified
Journal Article
Closed access
AKAlok Kumar
Alok Kumar
MSMohammad Autif Shahdhaar
Mohammad Autif Shahdhaar
JAJaywant H. Arakeri
Jaywant H. Arakeri
ASAtul Srivastava
Atul Srivastava

17 January 2012 in Experimental Heat Transfer
Verified
Journal Article
Closed access
SSS. Subudhi
S. Subudhi
JAJ. H. Arakeri
J. H. Arakeri
This study investigates the free convection and plumes dynamics over horizontal surfaces with parallel V-grooves. The convection is studied in a tank of water with the bottom surface being a smooth or grooved surface and the top of the water surface exposed to ambient. Two groove heights were used—10 mm and 3 mm—and the experiment was done with two values of aspect ratio—2.9 and 1.8 (aspect ratio is the width of the fluid layer/height of fluid layer). Heat flux at the bottom surface was from electrical heating. Beyond a certain critical temperature difference, enhanced heat transfer is obtained on the grooved surface compared to a smooth surface. Nusselt numbers are evaluated for both smooth and grooved surfaces and correlated using modified Rayleigh numbers. Visualization shows that the enhanced heat transport in the rough cavities cannot be ascribed to the increase in the contact area; rather, it must be the local dynamics of the thermal boundary layer.

19 September 2023 in Journal of Fluid Mechanics
Verified
Journal Article
Open access
PDF file
SMSuyog V. Mahulkar
Suyog V. Mahulkar
JAJaywant H. Arakeri
Jaywant H. Arakeri
We report an experimental study of the motion of a clapping body consisting of two flat plates pivoted at the leading edge by a torsion spring. Clapping motion and forward propulsion of the body are initiated by the sudden release of the plates, initially held apart at an angle .

1 August 2024 in Physics of Fluids
Verified
Journal Article
Closed access
PDF file
JAJaywant H. Arakeri
Jaywant H. Arakeri
Navneet KumarNavneet Kumar
Navneet Kumar
OMOmshree Mahapatra
Omshree Mahapatra
Heat transfer in flows created by buoyancy, or natural convection, is a widely studied topic across various disciplines spanning natural flows as well as those with engineering applications. The convective heat transfer rate on a surface is commonly represented by the Nusselt number (Nu), a ratio of convective to diffusive transport, expressed often as RanPrm, where Ra is the Rayleigh number, the buoyancy forcing parameter, and Pr the Prandtl number. Motivated by the observation that n∼1/3 for turbulent convection, which implies the heat flux is independent of the length scale (L, characteristic length related to the geometry), we propose an alternate and physically more meaningful non-dimensional heat transfer parameter, denoted by Cq. Cq is derived using only the near wall variables and does not contain L. For n=1/3, Cq is constant. Even for laminar convection, where n∼1/4, Cq∼Ra−1/12, a weak function of Ra. We show that for natural convection over several geometries and a wide range of Ra, the Cq values within a narrow range while the corresponding Nu values span several orders of magnitude. We also show that Cq is akin to the non-dimensional representation of wall shear stress, skin friction coefficient Cf. We believe that just like Cf, Cq will be an equally useful non-dimensional measure of heat transfer in natural convection flows.

16 September 2020 in Drying Technology
Verified
Journal Article
Closed access
Navneet KumarNavneet Kumar
Navneet Kumar
JAJaywant H. Arakeri
Jaywant H. Arakeri
We experimentally report evaporation characteristics from leaf-like surfaces having low open (exposed) area ratio. Even at much lower (1–10%) exposed areas, higher transpiration rates (60–70% compared to a bare water source) are sustained by a leaf. We mimic stomata, tiny openings present on the leaves using holes punched on silicon wafers (SW). The leaf-mimics have different opening diameters, ranging from 50 μ m to 400 μ m , but nearly the same open area of ∼ 25 m m 2 . The leaf-mimic with the smallest opening size was found to evaporate the most, while for the larger opening sizes it seems to decrease. In all the cases, evaporation ratio (ratio of the evaporation rate from the leaf-mimic to that of from a bare water surface at the same net incident radiation) increased with decreasing pore sizes; we compute this ratio based on three different definitions including one for the isothermal cases. In non-isothermal cases, we recognized that the variation in surface temperature led to nonlinear variation in the surface water vapor concentration. The effect of increased surface temperature, compared to a bare water surface in similar conditions, is missing in defining the evaporation ratios in previous approaches and thus we include it.

8 July 2024 in PLOS ONE
Verified
Journal Article
Open access
PDF file
DGDipendra Gupta
Dipendra Gupta
SSSanjay P. Sane
Sanjay P. Sane
JAJaywant H. Arakeri
Jaywant H. Arakeri
To understand the locomotory mechanisms of flying and swimming animals, it is often necessary to develop assays that enable us to measure their responses to external gust perturbations. Typically, such measurements have been carried out using a variety of gusts which are difficult to control or characterize owing to their inherently turbulent nature. Here, we present a method of generating discrete gusts under controlled laboratory conditions in the form of a vortex rings which are well-characterized and highly controllable. We also provide the theoretical guidelines underlying the design of gust generators for specific applications. As a case study, we tested the efficacy of this method to study the flight response of freely-flying soldier flies Hermetia illucens. The vortex ring based method can be used to generate controlled gusts to study diverse phenomena ranging from a natural flight in insects to the artificial flight of insect-sized drones and micro-aerial vehicles.