Nanocomposites have a great potential to work as efficient, multifunctional materials for energy conversion and photoelectrochemical reactions. Nanocomposites may reveal more improved photocatalysis by implying the improvements of their electronic and structural properties than pure photocatalyst. This paper presents the recent work carried out on photoelectrochemical reactions using the composite materials of ZnO with CdS, ZnO with SnO₂, ZnO with TiO₂, ZnO with Ag₂S, and ZnO with graphene and graphene oxide. The photocatalytic efficiency mainly depends upon the light harvesting span of a material, lifetime of photogenerated electron-hole pair, and reactive sites available in the photocatalyst. We reviewed the UV-Vis absorption spectrum of nanocomposite and photodegradation reported by the same material and how photodegradation depends upon the factors described above. Finally the improvement in the absorption band edge of nanocomposite material is discussed.

Structural investigations, optical properties and antibacterial performance of the pure Zinc Oxide (ZnO) nanoparticles (NPs) synthesized by mechano-chemical method are presented. The morphology, dimensions and crystallinity of the ZnO NPs were controlled by tweaking the mechanical agitation of the mixture and subsequent thermal treatment. ZnO nanoparticles in small (< 20 nm) dimensions with spherical morphology and narrow size distribution were successfully obtained after treating the mechano-chemically prepared samples at 250°C. However, higher temperature treatments produced larger particles. TEM, XRD and UV-Vis spectroscopy results suggested crystalline and phase pure ZnO. The NPs demonstrated promising antibacterial activity against Gram negative foodborne and waterborne bacterial pathogens i.e. Enteropathogenic E. coli (EPEC), Campylobacter jejuni and Vibrio cholerae as well as Gram positive methicillin resistant Staphylococcus aureus (MRSA), thus potential for medical applications. Scanning electron microscopy and survival assay indicated that most probably ZnO nanoparticles cause changes in cellular morphology which eventually causes bacterial cell death.

Control in size, crystallinity, and optical properties of ZnO nanoparticles (NPs) synthesized via coprecipitate method were investigated. A systematic change in particle size, crystallinity, and optical properties was observed by increasing synthesis temperature from 65°C to 75°C. A detailed study also suggested that smaller nucleation time is better to control the size distribution but the crystallinity will be compromised accordingly. Postannealing of ZnO NPs at 400°C also improves the crystal quality. Ultraviolet (UV) sensors were successfully synthesized and the results suggested that as‐synthesized ZnO NPs can be used as active material for sensor applications.

In this paper, synthesis and results of the low temperature sensing of carbon monoxide (CO) gas and room temperature UV sensors using one dimensional (1-D) ZnO nanostructures are presented. Comb-like structures, belts and rods, and needle-shaped nanobelts were synthesized by varying synthesis temperature using a vapor transport method. Needle-like ZnO nanobelts are unique as, according to our knowledge, there is no evidence of such morphology in previous literature. The structural, morphological and optical characterization was carried out using X-ray diffraction, scanning electron microscopy and diffused reflectance spectroscopy techniques. It was observed that the sensing response of comb-like structures for UV light was greater as compared to the other grown structures. Comb-like structure based gas sensors successfully detect CO at 75 °C while other structures did not show any response.