Electromagnetic shielding materials are special materials that can effectively absorb and shield electromagnetic waves and protect electronic devices and electronic circuits from interference and damage by electromagnetic radiation. This paper presents the research progress of intrinsically conductive polymer materials and conductive polymer-based composites for electromagnetic shielding as well as an introduction to lightweight polymer composites with multicomponent systems. These materials have excellent electromagnetic interference shielding properties and have the advantages of electromagnetic wave absorption and higher electromagnetic shielding effectiveness compared with conventional electromagnetic shielding materials, but these materials still have their own shortcomings. Finally, the paper also discusses the future opportunities and challenges of intrinsically conductive polymers and composites containing a conductive polymer matrix for electromagnetic shielding applications.

In this paper, inorganic oxide MgO nanoparticles-doped polymer dispersed liquid crystal (PDLC) films were made from a mixture of the prepolymer, SLC1717 liquid crystal, and MgO nanoparticles by the polymerization induced phase separation (PIPS) process. To observe the effect of MgO concentration, PDLC was dispersed with 0.2, 0.4, 0.6, and 0.8 wt.% MgO. Electro-optical properties of the films have been investigated using LCD parameter meter and Scanning Electron Microscope (SEM) at room temperature. It is established that MgO nanoparticles affect the microstructure of PDLC films significantly because of the formed agglomerates of MgO nanoparticles. Results show an improvement in the electro-optical properties and a decrease in the driving voltage for doped systems with MgO nanoparticles. When the doping amount of MgO is 0.8 wt.%, the threshold voltage (V_th) is reduced to about 7.5 V. Therefore, MgO-doped PDLC is expected to become an excellent choice in the field of energy-saving.

Perylene diimide derivatives were used as probes to investigate the effect of the molecular structures on the fluorescence quenching mechanism in a perylene diimide/graphene oxide system. The electrons transferred from the excited state of dyes to the conductive band of graphene oxide with different concentrations were determined by fluorescence spectra. The results indicated that the quenching efficiency of perylene diimides by graphene oxide was not only dependent on the difference between the lowest unoccupied molecular orbital level of dyes and the conduction band of the graphene oxide, but also mainly on the difference in the molecular structures.

Brightening polymer-stabilized bistable cholesteric liquid crystal (PSBCLC) films with doped fluorescent dyes were prepared using the polymerization-induced phase separation (PIPS) method. The transmittance performance behavior of these films in both states (focal conic and planar) and absorbance change in multiple dye concentrations were studied using a UV/VIS/NIR spectrophotometer. The change occurring in dye dispersion morphology with different concentrations was obtained by means of the polarizing optical microscope. The maximum fluorescence intensity of different dye-doped PSBCLC films was measured using a fluorescence spectrophotometer. Moreover, the contrast ratios and driving voltages of these films were calculated and recorded to demonstrate film performance. Finally, the optimal concentration of dye-doped PSBCLC films with a high contrast ratio and a relatively low drive voltage was found. This is expected to have great potential applications in cholesteric liquid crystal reflective displays.

Cholesteric liquid crystals (ChLC) with helical molecular structures are known for their ability to selectively reflect light at specific wavelengths. In this study, broadband reflective polymer-stabilized cholesteric liquid crystal (PSCLC) films in the near-infrared region were prepared by spin-coating MoO₂ nanoparticle (NP) dispersions. The effects of the dispersion concentration, the concentration of the polymerizable monomer, the light intensity and the polymerization time on the reflection wavelength were studied. The reflection bandwidth of the PSCLC film was broadened from 261 nm to 401 nm. It is confirmed that NPs have photothermal conversion ability, and their diffusion in the liquid crystal composite system is beneficial to the formation of non-uniform pitch distribution. Therefore, the PSCLC film prepared by the NP diffusion method is expected to be used for dynamic control of the sunlight transmission of energy-saving glass in buildings.

A high-yielding click reaction was used to synthesize a series of highly conjugated, symmetrical, as well as asymmetrical compounds with a benzene core. Cyclic voltammetry and ultraviolet/visible absorption spectroscopy were carried out, and proved that the side groups of the benzene derivatives played an important role in the energy gaps, and affected the third-order non-linear optical response. The maximum absorption wavelength of the series of benzene derivatives showed an obvious red-shift. Moreover, the addition of resilient electron-withdrawing groups significantly narrowed the energy levels as compared with precursors. The third-order nonlinear properties of this benzene derivative were tested by the Z-scan technique. The expected properties of this series of molecules were obtained, and it was found that the series of molecules undergoes a transition from reverse saturable absorption to saturable absorption, which has certain reference significance for a nonlinear optical field.