A modified 3D numerical model on the energy conversion process in the anode side of a Direct Methanol Fuel Cell (DMFC) system was constructed and validated to published experimental results. Systematic simulations were performed to investigate the underlying mechanisms of the energy conversion process, and the combined effects of inlet flow rate and input methanol concentration were summarized systematically. The increase of flow rate was found to be an effective strategy to accelerate the internal flow fields, while the diffusion layer was proposed to be a critical component in the design of high-performance DMFC. The frontier for optimal conditions of DMFC’s output was also determined, which can be helpful to improve the energy conversion performance of DMFC in practical applications.
The performance of proton exchange membrane fuel cells (PEMFCs) is greatly affected by their operating parameters, especially at high current densities. An advanced concentration loss model is proposed to improve a semi-empirical model describing PEMFC polarization, with the aim of accurate prediction at the whole current density interval from low to high levels. Experiments are designed to verify the improved semi-empirical model. Model comparison shows that the improved semi-empirical model has a better prediction accuracy and generalization ability than others. The effects of operating parameters and structural parameters on PEMFC performance are analyzed. The results indicate that a relatively high operating temperature, pressure, and gas diffusion layer (GDL) porosity can increase PEMFC performance. The influence of relative humidity and PEM thickness on PEMFC performance is different at low and high current densities. A relatively high humidity can improve PEMFC performance at a low current density, but PEMFC performance will be reduced if the relative humidity is too high at a high current density. A thinner PEM thickness can improve PEMFC performance at a low current density, but PEMFC performance does not necessarily improve with a decreasing PEM thickness at a high current density. Overall, the improved semi-empirical model realizes an accurate analysis of PEMFC performance from a low to high current density.
Automatic driving of trains can significantly reduce the energy cost and enhance the operating efficiency and safety. The automatic train driving system has to be an embedded system that can run onboard with low power, which necessitates an efficient inference model. In this article, a level-wise driving knowledge induction approach is proposed for embedded automatic train driving systems. The coincident driving patterns in the records of drivers with different experience levels suggest the suitability of a driving experience knowledge rule induction approach. We design a two-level learning approach to obtain both the driving experience pattern in fuzzy rule-based knowledge form and the detailed parameters of velocity and gear by regression learning methods. With 8.93% energy consumption reduction compared with average human drivers, the experiments indicate the effectiveness of our approach.
The coupling effects of clamping pressure and catalyst distribution are comprehensively considered to improve proton exchange membrane fuel cell (PEMFC) performance. Numerical models were constructed to study the performance changes and the corresponding internal states of PEMFC under different clamping pressures. Since the increased clamping pressure reduces the uniformity of current density, non-uniform designs with decreased catalyst loading under channel and increased catalyst loading under rib are proposed for performance improvement. A weighted objective function considering current density magnitude and uniformity was constructed, and the performances of different catalyst loading distributions were analyzed. Compared to the uniform distribution, the optimized distribution with a variation of −15% and 15% under channel and rib had the maximum objective function value of 17.24%. The deformation analysis of the gas diffusion layer and optimization of catalyst loading distribution based on deformation analysis provided a reference for the assembly of PEMFC and the production of MEA.