Sensitivity is one of the crucial factors in determining the quality of a fluorescence/phosphorescence-based gas sensor, and is estimated from the measurement of responses (I0/I, where I0 and I refer to the measured optical intensity of a sensor in absence and presence of analyte molecules) at various concentrations of analytes. In this work, we demonstrate phosphorescence-based optical oxygen sensors fabricated on highly porous anodic aluminum oxide (AAO) membranes showing dramatically high response. These sensors exploit the enormous surface area of the AAO to facilitate the effective interaction between the sensing molecules and the analytes. We spin-coat an AAO membrane (200 nm pore diameter) with a platinum-based oxygen sensing porphyrin dye, platinum(II) meso-tetrakis (pentafluorophenyl) porphyrin (PtTFPP), to fabricate a sensor exhibiting I0/I ~400 at 100% oxygen atmosphere. To address the generality of the AAO membrane, we fabricate a separate sensor with another porphyrin dye, platinum octaethylporphyrin (PtOEP), which exhibits an even higher I0/I of ~500. Both of these sensors offer the highest responses as an optical oxygen sensor hitherto reported. SEM and EDS analysis are performed to realize the effect of the increased surface area of the AAO membrane on the enhanced sensitivity.
The production of hydrogen (H2) through photoelectrochemical water splitting (PEC-WS) using renewable energy sources, particularly solar light, has been considered a promising solution for global energy and environmental challenges. In the field of hydrogen-scarce regions, metal oxide semiconductors have been extensively researched as photocathodes. For UV-visible light-driven PEC-WS, cupric oxide (CuO) has emerged as a suitable photocathode. However, the stability of the photocathode (CuO) against photo-corrosion is crucial in developing CuO-based PEC cells. This study reports a stable and effective CuO and graphene-incorporated (Gra-COOH) CuO nanocomposite photocathode through a sol-gel solution-based technique via spin coating. Incorporating graphene into the CuO nanocomposite photocathode resulted in higher stability and an increase in photocurrent compared to bare CuO photocathode electrodes. Compared to cuprous oxide (Cu2O), the CuO photocathode was more identical and thermally stable during PEC-WS due to its high oxidation number. Additionally, the CuO:Gra-COOH nanocomposite photocathode exhibited a H2 evolution of approximately 9.3 µmol, indicating its potential as a stable and effective photocathode for PEC-WS. The enhanced electrical properties of the CuO:Gra-COOH nanocomposite exemplify its potential for use as a charge-transport layer.