This article proposes a fractional-order sliding-mode control (FOSMC) method based on the super-twisting algorithm to compensate for a general form of mismatch uncertainties in a class of nonlinear systems. First, a new super-twisting algorithm-based fractional-order sliding-mode virtual control law is constructed to ensure that the state trajectory can converge to the equilibrium point and avoid the singular problem caused by the system state differential with fractional powers. Furthermore, the switching term in the virtual control law is softened by a $(2\alpha +1)$ -order integrator. Unlike the traditional boundary layer method, the fractional-order switching term in the designed control law has continuous derivatives so that a continuous actual control signal can be obtained without sacrificing control accuracy. With continuous control, the nonlinear system can respond quickly with high precision. Finally, simulation and experimental results demonstrate that the proposed control method exhibits excellent control performance in nonlinear systems with matched and mismatched uncertainties.
Lithium batteries are widely used in power storage and new energy vehicles due to their high energy density and long cycle life. The accurate and real-time estimation for the state-of-charge (SoC) and the state-of-health (SoH) of lithium batteries is of great significance to improve battery life, reliability, and utilization efficiency. In this paper, three cascaded fractional-order sliding-mode observers (FOSMOs) are designed for the estimation of SoC by observing the terminal voltage, the polarization voltage, and the open-circuit voltage of a lithium cell, respectively. Furthermore, to calculate the value of the SoH, two FOSMOs are developed to estimate the capacity and internal resistance of the lithium cell. The control signals of the observers are continuous by utilizing fractional-order sliding manifolds without low-pass filters. Compared with the existing sliding-mode observers for SoC and SoH, weaker chattering, faster response, and higher estimation accuracy are obtained in the proposed method. Finally, the experiment tests demonstrate the validity and feasibility of the proposed observer design method.