Shunli Peng

Dr. Shunli Peng

Light Alloy Research Institute, Central South University, Changsha, Guangdong, China

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 March 2023 in Materials
Verified
Journal Article
Open access
PDF file
SPShunli Peng
Shunli Peng
YWYunxin Wu
Yunxin Wu
TZTao Zhang
Tao Zhang
QXQiumin Xie
Qiumin Xie
ZYZhongyu Yuan
Zhongyu Yuan
LYLan Yin
Lan Yin
The thermal deformation behavior of the Mg–Gd–Y–Zr–Ag alloy was studied by isothermal hot compression tests at high temperatures. The flow stress increased with increased strain rates and decreased temperatures, first increasing and finally remaining stable with increased strain. A hot processing map was built. Using the processing map and microstructural analysis, the temperature should remain at 673–773 K for this alloy to ensure the deformation quality. The primary softening mechanism is discontinuous dynamic recrystallization (DDRX). Rising temperatures and declining strain rates facilitated the emergence and growth of Dynamic recrystallization (DRX) grains. An original JC (O–JC) model and a modified JC (M–JC) model were established. The M–JC model indicated a better prediction than the O–JC model. Still, it was deficient in predicting flow stresses with insufficient coupling effects. Hence, based on the M–JC model, a newly modified JC (NM–JC) model, which further enhances the interaction between strain and strain rate as well as strain and temperature, is proposed. Its projected values can better align with the tested values.

11 February 2024 in Metals
Verified
Journal Article
Open access
PDF file
QXQiumin Xie
Qiumin Xie
YWYunxin Wu
Yunxin Wu
YWyuanzhi wu
yuanzhi wu
SPShunli Peng
Shunli Peng
To investigate the heat transfer coefficient (HTC) of a newly developed rare-earth wrought magnesium alloy under different cooling rates, the experiment of solution treatment followed by water quenching or air cooling process was carried out for calculation by lumped capacitance method (LCM) and optimized by inverse heat transfer method (IHTM), and cooling temperature curves were simulated afterward. In water quenching, the larger the temperature difference between the sample and water, the larger the maximum HTC, and the earlier it reached the maximum value, and in air cooling the HTC became larger with the airflow speeds increased. In LCM, the peak values of the HTC were 2840 W/(m2·°C) in water quenching and 54 W/(m2·°C) in air cooling. The corresponding HTC was 2388 W/(m2·°C) in IHTM. The maximum absolute average relative error (AARE) of temperature simulation in water quenching decreased from 8.46% in LCM to 2.45% in IHTM. The residual stress(RS) of a large conical component was simulated using both non-optimized and optimized HTC, the RS in the IHTM was ~30 MPa smaller than that in the ILCM, because the corresponding HTC was smaller, and the comparison of the simulation results with the measurements revealed that the RS using HTC in the IHTM is more accurate.