SILP (supporting ionic liquid phase) catalysts for peroxide thiophene oxidation were obtained on silica gel, they included imidazole cations with sulfonic acid group and phosphotungstate anions. The composition of the active phase and the surface structure of the catalysts are characterized by a set of modern physicochemical methods, including mass spectrometry using the SALDI technique. It was found that the organic cation structure affects the stability of heteropolyanions, decomposition processes in the SILP and the catalytic properties of the samples. SILP catalysts are effective in desulfurization of the diesel fraction and provide fuel with an S content of less than 10 ppm.
Comparative analysis of heterogeneous catalysts for the peroxide oxidation of thiophene is conducted. The catalysts are imidazole ionic liquids (ILs) containing anions of phosphomolybdic and phosphotungstic acids immobilized on mineral supports. Immobilization is implemented by the covalent bonding of an IL fragment to a silica surface or by adsorption on alumina. The catalysts are active not only in the model oxidation of thiophene in isooctane, but also in the desulfurization of a straight-run diesel fraction and the “synthetic crude oil” derived from oil shale.
The complexes of copper chloride with quaternary ammonium bases supported on silica are highly active in the reaction of carbon tetrachloride with decane was found in the presence of an electron donor (ethanol). The effectiveness of the catalysts depends on the method of their deposition onto the support. The catalysts obtained as a result of covalent binding with the surface through the formation of siloxane bonds (immobilization) exhibit high stability and higher activity than the analogues prepared by the impregnation of the support with the catalytic complex. The introduction of ethanol into the reaction system substantially increases the activity and stability of all of the catalysts.
The peroxide oxidation of thiophene, thioanisole, and dibenzothiophene in the presence of Ce, Zr, Ce + Zr, W, and W + Zn oxide layers formed by plasma electrolytic oxidation on the titanium surface was studied. The composition of the resulting composites was found to affect the activity and conversion of the organosulfur substrates. It was shown by the radical inhibition method that the composites differed in the mechanism of their catalytic action.