The complexes of copper chloride with quaternary ammonium bases supported on silica are highly active in the reaction of carbon tetrachloride with decane was found in the presence of an electron donor (ethanol). The effectiveness of the catalysts depends on the method of their deposition onto the support. The catalysts obtained as a result of covalent binding with the surface through the formation of siloxane bonds (immobilization) exhibit high stability and higher activity than the analogues prepared by the impregnation of the support with the catalytic complex. The introduction of ethanol into the reaction system substantially increases the activity and stability of all of the catalysts.
This study presents microstructural and phase compositional characterization of 30-μm-thick bismuth ferrite (BiFeO3) films screen-printed on Ag, Au and Pt metal foils. Ag is shown to be chemically incompatible with BiFeO3 at temperatures higher than 750°C. X-ray diffraction and scanning electron microscopy analysis reveal that an almost single phase BiFeO3 thick film can be obtained on Au and Pt substrates after sintering at 750°C, while sintering at 820°C results in increased densification of BiFeO3. This work represents another step further towards the integration of BiFeO3 into thick film structures.
In this work the screen-printed piezoelectric 0.65Pb(Mg1/3Nb2/3)O3-0.35PbTiO3 thick films were prepared on metalized low-temperature co-fired ceramic substrates. Such substrates are interesting for micro-electro mechanical systems, for example for piezoelectric sensors and actuators. The prepared thick films exhibit the piezoelectric coefficient d33 equal to 120 pC/N.