In this paper, a hybrid magnetic bearing (HMB) prototype system is designed and analyzed. Two compact bearings are used to suspend the rotor in five degrees of freedom. Electromagnets are used for axial suspension of the rotor, while permanent magnets are used for the passive radial stability. A brushless DC motor is designed in order to rotate the shaft around its axis. The 3-D finite-element model of the HMB system is established and distribution of magnetic fields in the air gaps and magnetic forces on the rotor under various control currents and displacements is calculated. A nonlinear adaptive sliding-mode controller is designed for the position control of the rotor in axial direction. Since the control characteristics of the active magnetic bearing system are highly nonlinear and time varying with external interference, a radial basis function compensator is designed first, and then, a sliding-mode control law is used to generate the control input. The stability analysis for the designed controller is given based on the Lyapunov theorem. Experimental setup is built to guide the design process. The performance of the HMB system based on the designed control algorithm is evaluated under different operating conditions.
12 October 2017 in IEEE Transactions on Industrial Electronics
In this paper, a novel design for the axial flow blood pump is proposed, based on the bearingless permanent magnet (PM) motor concept. The design of the impeller, the rotor, and the stator is explained. The axial length of the impeller is optimized based on the finite-element analysis (FEA), and because of reduced axial length of the rotor, only one radial active magnetic bearing is used, whose functionality is embedded in the same stator, which is used for generating motor torque. A novel design of the rotor and the stator is proposed for measuring the radial position of the rotor using four linear Hall effect sensors. This sensor assembly can measure the radial position of the rotor with good accuracy. The angular position of the rotor is measured with two Hall effect sensors. The 3-D FEA of the complete system is performed, and suspension forces, stiffness, and torques are evaluated under various control conditions. The control strategy for the bearingless PM motor based on the Hall effect position sensors is explained. The experimental setup is built in order to guide the process of design. The experimental results of the system are evaluated under different operating conditions and compared with FEA results.
Phase change material (PCM)-based thermal energy storage units (TESU) have very low thermal conductivity that compromise their charging and discharging rate. The present study focuses on an enhancement in charging rate as well as an increase in the uniformity of the melting rate. A rectangular cavity consisting of two horizontal partial fins is studied. The horizontal partial fins are placed symmetrically in a PCM-based TESU. In the current work, the melting rate of PCM was enhanced using asymmetric arrangement while keeping all other parameters the same, thus showing the positive effect of asymmetric configuration in such storage systems. The position and the pitch of each fin is optimized to improve heat transfer characteristics of the TESU. The numerical investigation of the problem is performed. TESU with asymmetrically placed fins show better performance in terms of higher charging rate as well as uniformity of the charging rate. The asymmetric placement of the fins suggested by present study increased the charging rate by 74.3% on average as compared to the symmetrically placed fins in the storage system. The charging rate uniformity is improved by 43.7%. The asymmetric fin’s placement conserved the convection strength for a longer melting duration and so increased the Nusselt number by 80.2% as compared to the symmetrically placed fins. Thus, it can be concluded that the performance of asymmetric fins is better in the charging of PCMs than the symmetrically placed fins in a PCM-based TESU.