The crystallinity properties of perovskite influence their optoelectrical performance in solar cell applications. We optimized the grain shape and crystallinity of perovskite film by annealing treatment from 130 to 170 °C under high humidity (relative humidity of 70%). We found that the grain size, grain interface, and grain morphology of the perovskite are optimized when the sample was annealed at 150 °C for 1 h in the air. At this condition, the perovskite film is composed of 250 nm crystalline shape grain and compact inter-grain structure with an invincible grain interface. Perovskite solar cells device analysis indicated that the device fabricated using the samples annealed at 150 °C produced the highest power conversion efficiency, namely 17.77%. The open circuit voltage (Voc), short-circuit current density (Jsc), and fill factor (FF) of the device are as high as 1.05 V, 22.27 mA/cm2, and 0.76, respectively. Optoelectrical dynamic analysis using transient photoluminescence and electrochemical impedance spectroscopies reveals that (i) carrier lifetime in the champion device can be up to 25 ns, which is almost double the carrier lifetime of the sample annealed at 130 °C. (ii) The interfacial charge transfer resistance is low in the champion device, i.e., ~20 Ω, which has a crystalline grain morphology, enabling active photocurrent extraction. Perovskite’s behavior under annealing treatment in high humidity conditions can be a guide for the industrialization of perovskite solar cells.
Limitations on the hard module and the lack of availability of technology-based learning media led to a lack of student motivation in learning physics. As a result, it is necessary to develop a constructivism-based electronic physics module. The objective of this research is to know the validity of constructivism-based electronic physics module for 1st student in Senior high school. This research is research and development research. Feasibility tests of the electronic module are carried out through the validation. Validation was carried out by three validators. Based on validation, it showed that constructivism-based electronic physics module that was developed is very valid with a percentage of 89.08%.AbstrakKeterbatasan pada modul cetak serta kurangnya ketersediaan media pembelajaran yang berbasis teknologi menyebabkan kurangnya motivasi siswa dalam mempelajari fisika. Untuk itu perlu dikembangkan sebuah Modul Elektronik fisika berbasis konstruktivisme. Penelitian ini bertujuan untuk menghasilkan Modul Elektronik Fisika yang valid untuk siswa Kelas X SMA. Penelitian ini adalah penelitian pengembangan (research development) dengan menggunakan model 4-D. Pada tahap develop dilakukan pengembangan modul dengan divalidasi oleh 3 orang validator. Berdasarkan hasil validasi terhadap modul elektronik fisika berbasis konstruktivisme yang dikembangkan adalah sangat valid dengan persentase 89,08%.