Excavation damage zones that occur around tunnels usually lead to a change in rock permeability, which has an impact on the water inflow into tunnels and even induces water inrush disasters. For a better understanding of the effect of the excavation damage zone, analytical solutions that consider the excavation damage zone are developed based on the review and modification of the solutions that consider linings and grouting circles. Then, both analytical solutions and the finite element method are applied to estimate the water inflow, and the results are in good agreement. The effect of the excavation damage zone on water inflow is analyzed based on an impact factor of the excavation damage zone and evaluated in a real engineering case, and the seepage-preventing effects of grouting are discussed. The results reveal that the water inflow increases with increasing permeability and thickness of the excavation damage zone and that there is a limit for the effects of the excavation damage zone. In addition, the effect is stronger for underwater tunnels with small water inflows and stabilizes gradually as the magnitude of water inflow increases. The increase in the impermeability and thickness of the lining and grouting circle can reduce the effect.
Constructing and maintaining a three-dimensional network structure with high porosity is critical to the preparation of silica aerogel materials because this structure provides excellent properties. However, due to the pearl-necklace-like structure and narrow interparticle necks, aerogels have poor mechanical strength and a brittle nature. Developing and designing lightweight silica aerogels with distinct mechanical properties is significant to extend their practical applications. In this work, thermally induced phase separation (TIPS) of poly(methyl methacrylate) (PMMA) from a mixture of ethanol and water was used to strengthen the skeletal network of aerogels. Strong and lightweight PMMA-modified silica aerogels were synthesized via the TIPS method and supercritically dried with carbon dioxide. The cloud point temperature of PMMA solutions, physical characteristics, morphological properties, microstructure, thermal conductivities, and mechanical properties were investigated. The resultant composited aerogels not only exhibit a homogenous mesoporous structure but also achieve a significant improvement in mechanical properties. The addition of PMMA increased the flexural strength and compressive strength by as much as 120% and 1400%, respectively, with the greatest amount of PMMA (Mw = 35,000 g/mole), while the density just increased by 28%. Overall, this research suggests that the TIPS method has great efficiency in reinforcing silica aerogels with less sacrifice of low density and large porosity.
Silica aerogels are highly attractive due to their outstanding properties, including their low density, ultralow thermal conductivity, large porosity, high optical transparency, and strong sorption activity. However, their inherent brittleness has limited widespread applications. Constructing a robust, highly porous three-dimensional network is critical to achieving the desired mechanical properties in aerogels. In this study, we introduce a novel synthesis route for fabricating lightweight and mechanically strong aerogels by incorporating poly(ethylene-co-vinyl alcohol) (EVOH) through thermally induced phase separation (TIPS). EVOH exhibits upper critical solution temperature (UCST) behavior in a mixture of isopropanol (IPA) and water, which can be utilized to reinforce the silica skeletal structure. Robust aerogels were prepared via the sol–gel process and TIPS method, followed by supercritical CO2 drying, yielding samples with bulk densities ranging from 0.136 to 0.200 g/cm3. N2 physisorption analysis revealed a mesoporous structure, with the specific surface area decreasing from 874 to 401 m2/g as EVOH content increased from 0 to 80 mg/mL. The introduced EVOH significantly enhanced mechanical performance, raising the flexural strength and compressive strength to 0.545 MPa and 18.37 MPa, respectively—far exceeding those of pure silica aerogel (0.098 MPa and 0.74 MPa). This work demonstrates the effectiveness of the TIPS strategy for developing high-strength, low-density silica aerogels with well-preserved porosity.