This paper proposes a convex time-optimal trajectory planning method for industrial robotic manipulators with jerk constraints. To achieve smooth and efficient trajectories, the square of the pseudo velocity profile is constructed using a cubic uniform B-spline, and a linear relationship is defined with the control points of the B-spline to preserve convexity in the pseudo states. Bi-linear and non-convex jerk constraints are introduced in the optimization problem, and a convex restriction method is applied to achieve convexity. The proposed method is evaluated through three case studies: two contour following tasks and a pick-and-place task. Comparative optimization results demonstrate that the proposed method achieves time optimality and trajectory smoothness simultaneously in the reformulated and jerk-restricted optimization problem. The proposed method provides a practical approach to address the non-convexity of jerk constraints in trajectory optimization for industrial robotic manipulators. Note to Practitioners —This work was motivated by the challenge of generating smooth and time-optimal trajectories for industrial manipulators while considering jerk and dynamic constraints. Existing approaches typically use multi-objective methods that treat jerk constraints as soft constraints. In contrast, this work proposes a B-spline-based convex optimization method that treats jerk constraints as hard constraints. Three case studies are conducted, involving butterfly-type, door-type and ‘OPTEC’-type paths, with the UR5 cooperative robot. The numerical and experimental results demonstrate that the proposed method sacrifices some time optimality to achieve trajectory smoothness and computational efficiency due to the convex restriction reformulation of the jerk constraints. Moreover, the proposed method is applicable to general industrial manipulators. Supplementary video is available at https://youtu.be/gVz5IuPKD-o.
This paper proposes a compact and reconfigurable variable stiffness actuator (VSA) using disc spring which is named as SDS-VSA (symmetrical disc spring variable stiffness actuator). To enhance the actuator’s torque density, symmetric compression springs are integrated into the cam-roller-spring mechanism, and a disc spring combination design is employed instead of conventional springs. The disc spring configuration is tailored to achieve a broader stiffness range within a limited size, aligned with stiffness and dimensional requirements. Subsequently, the dynamics of the cam-roller-spring mechanism are derived. To tackle the challenge of strong coupling dynamics, a decoupled modeling method by introducing mismatched and matched disturbances is proposed. A back-stepping tracking controller and proportional-derivative (PD) controller with feedforward are proposed to track the link-side and stiffness motor-side trajectories, respectively. Tracking experiments under significant stiffness alteration are conduced to verify the performance of the prototype SDS-VSA.
4 November 2024 in Journal of Mechanical Science and Technology
Variable stiffness actuator is a new actuation of robot which is inspired by motor control of human arm. And it is promising way to exploit the human‐like performance and human‐like motion. However, due to the mechanical complexity and redundancy of the actuators, it is not trivial to control the variable stiffness actuated robot to perform a human‐like motion. In this paper, the weight lifting problem with variable stiffness actuated robot is studied. Then, the original problem is formulated as a constrained optimal control problem and transformed as a general nonlinear programming problem with Gauss pseudospectral method. Simulation studies demonstrate the effectiveness of the proposed method compared with the iLQR approach. Furthermore, the simulations results are presented to show the influence of stiffness variation of variable stiffness actuators on the weight lifting problem.