Vibration techniques have been employed for detecting the presence and monitoring the progression of damage in structures. Pinpointing the location of damage is a more complicated and elaborate task. This paper presents modal analysis techniques for locating damage in a wooden wall structure by evaluating damage-sensitive parameters such as resonant pole shifts and mode shapes, residue and stiffness changes. Artificial damage (simulating termite degradation) was created in one of the walls of a specially constructed room. The wall was excited using an impact hammer and its frequency response measured using a laser vibrometer. Resonant poles (plotted in the s-plane) were used for identifying modes that are sensitive to damage, since not all modes are equally affected by the presence of damage. The damaged region was identified by visual comparison of the deformation mode shapes before and after damage. The modal residue and stiffness changes were also quantified for a better representation of the damage location.

Bird strikes have long been a source of concern for all airlines across the world. It is the most significant design criterion for aircraft engine fan blades. As it is not practical to manufacture and test aviation engines repeatedly for minor design modifications, simulation analysis can be used to investigate strategies to reduce the influence of a bird strike on a jet engine by employing proper design and manufacturing processes for blades. This study proposes using two fibers (hybrid) instead of the single-fiber composite blade presently in use to address delamination problems. As an idea validation test, the coupon-level analysis results are validated using a four-point bend test of similar-size coupons. Following this validation, dynamic analysis is used to investigate the impact behavior of a rectangular plate subjected to a bird strike. The current research focuses on analyzing bird strikes on a hybrid composite fan blade using blade-level models. This study concentrates on the position of the bird’s impact and the joint region length of two materials. The results show that the joint region with a 40% length of glass composite shows the optimum level of normalized interlaminar shear strain in all three impact locations.

Fan blades are one of the most important components of an aircraft engine. Bird strikes on fan blades have always been a cause of worry and it can cause slices of birds hitting other parts of the engine which may lead to greater damages. Bird strikes cannot be completely avoided. However, reduction of the impact of a bird on jet engines can be achieved by suitable design and manufacturing, through the simulation analysis. Although current composite blades can withstand the bird strike impact, some delamination failures are still observed on the trailing edge side of the blade, possibly due to vibration bending modes This paper talks about using two fibers in composite blade instead of the current single fiber one. For this to be feasible, two fiber joints at various locations on the blade have to be properly designed. The design criteria used here is the lowest inter-laminar shear strain level at critical joint locations. Suitable size coupon models in FEA with hybrid joints inside are used to simulate the blade bending with appropriate boundary conditions. The coupon models were developed by using the ANSYS APDL and linear static analysis was performed for different repetitive layups and varying layer by layer joint locations. The coupon joint designs with minimum inter-laminar shear strains are shortlisted to be recommended for use in sub-element and blade models.