The present work reports the fabrication of a ferroelectric tunnel junction based on a CMOS compatible 2.8 nm-thick Hf0.5Zr0.5O2 tunnel barrier. It presents a comprehensive study of the electronic properties of the Pt/Hf0.5Zr0.5O2/Pt system by X-ray photoelectron and UV-Visible spectroscopies. Furthermore, two different scanning probe techniques (Piezoresponse Force Microscopy and conductive-AFM) were used to demonstrate the ferroelectric behavior of the ultrathin Hf0.5Zr0.5O2 layer as well as the typical current-voltage characteristic of a ferroelectric tunnel junction device. Finally, a direct tunneling model across symmetric barriers was used to correlate electronic and electric transport properties of the ferroelectric tunnel junction system, demonstrating a large tunnel electroresistance effect with a tunneling electroresistance effect ratio of 20.
Biomedical electronics research targets both wearable and biocompatible electronic devices easily adaptable to specific functions. To achieve such goals, stretchable organic electronic materials are some of the most intriguing candidates. Herein, we develop highly stretchable poly-(3,4-ethylenedioxythiphene) (PEDOT) doped with tosylate (PEDOT:Tos) nanofibers. A two-step process involving electrospinning of a carrier polymer (with oxidant) and vapor phase polymerization was used to produce fibers on a polydimethylsiloxane substrate. The fibers can be stretched up to 140% of the initial length maintaining high conductivity.
Graphene films were exposed to low-pressure capacitively coupled (E-mode) and inductively coupled (H-mode) argon radio frequency plasmas to investigate damage formation by very-low-energy ion irradiation. In the H-mode, plasma parameters were assessed by a Langmuir probe and plasma sampling mass spectrometry to determine the conditions of fixed ion fluence but with different average ion energies. The populations of argon metastable and resonant argon atoms were also measured by optical absorption spectroscopy to determine their contribution to the total energy flux during plasma treatment. In the H-mode, in which plasma-graphene interactions are dominated by ion irradiation effects, Raman spectroscopy reveals a significant rise in the D/G ratio and full width at half maximum of the G peak as well as the onset of graphene amorphization, even at very low ion energies (between 7 and 13 eV). In the E-mode characterized by comparable ion energy but much lower ion density, significant damage is also observed, a feature ascribed to the additional energy flux linked to the de-excitation of metastable argon species on the graphene surface.
Non-toxic organosilicon coatings with hydrophobic properties were deposited on Kraft paper films using atmospheric-pressure dielectric barrier discharge. In order to assess the applicability of the plasma-deposited coating in the food packaging industry, its stability in different liquids (i.e., food simulants) was studied. Chemical analyses reveal that the food simulants, namely, de-ionized water, acetic acid, ethanol, and heptane, do not significantly alter the chemical composition or the hydrophobicity of the coatings. Based on inductively coupled plasma-optical emission spectroscopy analyses, the amount of Si released from the plasma-deposited coating is less than that typically detected in tap water. Overall, the results obtained suggest that hydrophobic plasma-deposited organosilicon coatings have great potential for use in food and wet packaging applications, especially considering their environmentally friendly character.
The direct control of the tunneling current as a function of electric polarization in ferroelectric tunnel junctions has recently attracted noticeable attention through the availability of the CMOS compatible ferroelectric hafnium zirconium oxide ( ). While a lot of progress has been made in the understanding of ferroelectric tunnel junctions, the control and optimization of the volume fraction of the polar orthorhombic phase are still in its infancy and raise the question whether all observed resistive switching events are necessarily associated with polarization reversal. Trap-assisted tunneling is also able to modulate the current density through a field-induced variation of the oxygen vacancy density across the tunnel junction. The amplitude of the effect should depend on the pre-existing density of oxygen vacancies introduced during the fabrication. Here, by controlling the oxygen partial pressure during the RF magnetron sputtering deposition of the non-polar monoclinic phase of thin films of approximately 3 nm, we demonstrate tuning of its transport mechanism due to the formation of oxygen vacancies. We show that two mechanisms dominate the current transport depending on the average distance between traps. For large oxygen content in the thin film, direct tunneling (DT) is the dominant transport mechanism, while the electrical conductivity in the oxide can be described by the phonon-assisted tunneling between traps (PATTs) for the oxygen deficient thin film. We derive a critical inter-trap distance and a critical thickness value that explains the transition from DT to PATT mechanism in thin films.
The requirements of nanocomposite thin films, having non-aggregated nanoparticles homogeneously dispersed in the matrix, have been realized using a new method of Direct Liquid Reactor-Injector (DLRI) of nanoparticles. In this approach, unlike conventional aerosol-assisted plasma deposition, the nanoparticles are synthesized before their injection as an aerosol into plasma. In our experiments, we have used two different plasma reactors, namely an asymmetric low-pressure RF plasma reactor and a parallel plate dielectric barrier discharge at atmospheric pressure. Our results have shown that DLRI can be easily coupled with various plasma processes as this approach allows the deposition of high-quality multifunctional nanocomposite thin films, with embedded nanoparticles of less than 10 nm in diameter. Hence, DLRI coupled with plasma processes meets the specifications for the deposition of multifunctional coatings.