The presence of gypsum in soil has a high effect on the mechanical and physical properties of soil. This effect depends fundamentally on the type and quantity of gypsum existent in the soil. The present study attempts to improve the physical and mechanical properties of gypseous soil using a new type of pozzolanic material discovered as a pozzolanic material from attapulgite clay. It is called “High Reactivity Attapulgite” HRA. The objective of this study is to investigate the ability of this material to be a moderate stabilizer material used for treating soil. The soil was obtained from one location at depth 1 m with 28% gypsum content. High Reactivity Attapulgite (HRA) was used as a replacement with soil in different percentage (5%, 10%, 20%, and 40%). Experimental tests included Atterberg limits, modified compaction, strength, unconfined compression and consolidation. Then all the tests were conducted on specimens with HRA content that was varied in the range 5-40%. The results showed the important effect of HRA on gypseous soil, as was seen from the reduction in the collapse potential by about 13-90%, and the increase in the unconfined compressive strength from 88 kPa to 271 kPa upon the addition of HRA by 5-40%.
1 January 2025 in Journal of Engineering and Sustainable Development
The bearing capacity of footing with and without a skirt has been investigated using a series of finite element analyses using the Geo-slope program. Several models were conducted with varying skirt depths and slope crest lactations. The impact of slope inclination b, height H, and soil undrained shear strength Cu were also covered. The paper findings demonstrated that several factors significantly change the estimate of bearing capacity with great effectiveness that is ranging between 16.7% and 52.7% for D/B = 0.5, 1 and 1.5, and L/B (distance from edge slope/width of footing) = 0, 1, 4 and 8 respectively, and 18.2%, 36.4, 57.6%; 11.6%, 17.6%; 27.9% kPa, for D/B (depth of skirt/width of footing) = 0.5, 1 and 1.5 and L/B = 0, 1, 4 and 8 respectively in case β=10° slope inclination with H/B =2 and Cu=60 kPa for D/B = 0.5, 1 and 1.5 and L/B = 0, 1, 4 and 8 with Cu=20 kPa respectively in case β=10° slope inclination with H/B =2, also the critical L/ B ratio is 4. Beyond this value, the increase in bearing capacity became constant.
Pavement is a multi-layered system in which each layer’s strength is reflected on the pavement. Because of their economic and engineering qualities, various secondary materials like slag, bottom ash, concrete debris, foundry sands, and other waste materials are evaluated for usage as alternatives for natural aggregates or materials in the applications of the civil engineering. The present study evaluates the effect of using waste material (reclaimed concrete aggregate and foundry sand) at a different percentage (5%, 10%, 15%) by weight of base layer on CBR and MR at different soaking periods (4, 14, and 30 days). The results show that CBR and MR values increase as the FS % increased until reached 10% then the effect is reduced while the rate of increase in CBR and MR is small after 10% of RCA. Also, results show that reduced in CBR and MR as increased in soaking periods after 4 days.