A remarkable number of scientific papers are available in the literature about the bulk amorphous alloys and metallic glasses. Today, DSC is an essential tool for amorphous alloys research and development, and of course for quality assurance. In many cases, users seek to examine the determination of only one or two properties, although much more information can be obtained from the measurements. The research involved structural relaxation, Curie temperature, glass temperature, crystallization, phase separation, nanocrystalline volume fraction, melting point and liquidus temperature determination subjects and kinetics of microstructural transformations induced by thermal treatment. We collected and present the information that can be obtained with this technique and draws the reader’s attention to some potential problems related to data interpretation.
Present paper deals with the development of geopolymer foam prepared from ground F class power station fly ash. The effect of the fly ash fineness on the rheology of the geopolymer paste and the foam properties have been investigated. The raw fly ash was ground in a ball mill for various duration, 5, 10, 20, 30, 60 and 120 min. Geopolymer paste was prepared from the raw and ground fly ash with NaOH – sodium silicate mixture as alkaline activator. Geopolymer foam production was made using H2O2as foaming agent. Additionally, the geopolymer material structure was investigated by Fourier transform infrared spectrometer, the foam cell structure was monitored using optical microscopy. The rheological behaviour of the geopolymer paste changed due to the grinding of fly ash (from Bingham plastic to Newtonian liquid). Grinding of fly ash has a significant effect on the physical properties as well as on the cell structure of the geopolymer foam.
In the present study the analysis of 5 different mechanisms of porosity formation during laser melt injection (LMI) technology were performed. Experiments were supported by thermodynamic and fluid-flow analysis. Special attention should be paid to i. clean the surface of the substrate, ii. use inert shielding gas, iii. use proper particle size and gas velocity, iv. use proper laser power and laser beam velocity to control bath temperature and v. deoxidize the surface of the added particles.
The aim of the present work is to investigate the microstructure of Al-Pb monotectic surface layers generated by a laser surface alloying technique on the surface of an Al-4Cu-1.5Si-0.5Mg alloy. Monotectic alloys are generally used as materials for sliding bearings. Layers of a monotectic alloy generated by laser surface alloying have a potential for superior properties, because the rapid solidification during this process results in fine precipitation structures which can act as solid lubricant. The structure of the Al-Pb monotectic surface layers was observed in the light microscope and the scanning electron microscope. Volume fraction and size distribution of lead particles were determined by quantitative image analysis. Pin-on-disc experiments were carried out to characterize and compare the tribological properties of the Al-Pb monotecitc layers and cast Al-Cu-Si-Mg alloys.
1 December 2014 in Journal of Alloys and Compounds