The focus of the current paper is the investigation of different local stress calculation methods for fatigue design. To evaluate the accuracy and applicability of the hot-spot and effective notch stress (ENS) fatigue assessment methods an experimental and numerical research program is carried out at the BME Department of Structural Engineering, in Hungary. Two types of structural details are tested using 32 test specimens, a cruciform and a gusset plate type joint. The test results and the accompanying numerical calculation results are statistically evaluated and compared. Analysing the results of the fatigue tests and numerical calculations, it is concluded, that both the hot-spot and the ENS method could be used for fatigue design of the cruciform joints according to the recommendation of the IIW (Hobbacher in Recommendations for fatigue design, Springer, Paris, 2004). However, the rules of the ENS method needs improvement, if used for the design of gusset plate type joint. According to the current results, the ENS method can be adjusted to make applicable for the gusset plate joints as well, recommendation for that is presented in the current paper.
The numerical model-based design is commonly applied to steel structures using advanced numerical models and analysis. These models often contain stress concentration zones, which can cause problems for designers within the evaluation process. There are two basic questions to answer in the design: (i) are these stress concentrations real physical stresses or numerical singularities and (ii) should these stresses be considered in the design process or can be neglected? The current paper shows a proposal to separate the real physical stresses from the numerical stress concentrations and an improved design method is introduced to consider or neglect them in the daily design. The proposed evaluation method is presented through a design example taken from the daily bridge design practice. The calculation method of the design check is presented first by using (i) linear analysis and (ii) geometrical and material non-linear analysis. Based on the comparison of these two calculation methods the evaluation process of the stress concentration zone is presented as an example. The paper introduces an evaluation method for the stress concentration zone, which can be applied to different structures similarly.
1 January 2016 in Periodica Polytechnica Civil Engineering
Numerical simulations make the improvement of fabrication process and welding technology. Numerical simulations make the improvement of fabrication process and welding technology possible. Using finite element method the most important information about welded specimens can be determined such as deformed shape, residual stresses or even microstructural properties like phase proportions or hardness. The current study focuses on the modelling background of welding processes and the effects of different welding parameters on residual stresses and deformations. The paper focuses on heat sources, temperature dependent material properties and the development of a thermo-mechanical analysis. The virtually fabricated specimens are further analysed to investigate the stability behaviour.