The short-term sensitivity of a several-kilometers long fiber-optic gyroscope is limited mainly by thermal phase noise and relative intensity noise. Increasing the phase modulation frequency decreases the thermal phase noise but not the relative intensity noise since it behaves as white noise. Here, we propose and experimentally demonstrate that the angular random walk can be effectively decreased by suppressing relative intensity noise at the modulation frequency and its third-order harmonic using direct feedback to the drive current of a superluminescent diode. Our simultaneous suppression of thermal phase noise and relative intensity noise yields an angular random walk of 15 μdeg/ √h and a bias instability of 33 μdeg/h using a fiber coil with a length of 5 km and an effective area of 280 m 2 for a measurement time of 40 hours.
Optimizing the bias modulation of a fiber-optic gyroscope is crucial to improving its precision. In this study, we propose and demonstrate the use of multiple harmonics of sinusoidal modulation as an intermediate alternative to the widely used modulation methods: sinusoidal and square-wave modulation. We show that this alternative integrates the advantages of each modulation method by providing a smooth modulation that produces a clean, spike-free output and a satisfactory signal-to-noise ratio. By using three harmonics of modulation in combination with a high frequency to reduce thermal phase noise, we obtained an angular random walk of and a bias instability of . This is the highest performance ever reported for fiber-optic gyroscopes.
The sensitivity of an interferometer depends on its readout scheme. However, little attention has been paid to the readout schemes of atom interferometers from the viewpoint of their sensitivity. The difference in sensitivity between readout schemes or their optimization has not been considered in the literature. Herein we analytically calculate the sensitivities of an atom interferometer with typical readout schemes by applying the two-photon formalism, which was developed for optical interferometers to deal with quantum noise. Our calculations reveal that by using sinusoidal phase modulation, the sensitivity can surpass that obtained by the conventional phase sweeping scheme. The superiority of this phase modulation scheme for both cold and thermal atomic beams is demonstrated. In addition, we show that the phase modulation scheme is advantageous for atom-flux fluctuation and resists atom-flux drift. This study performs a general analysis of the sensitivity of atom interferometers and identifies an advantageous readout scheme.