Pierre Beauchêne

Dr. Pierre Beauchêne


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 June 2023 in Materials
Verified
Journal Article
Open access
PDF file
RARomain Agogué
Romain Agogué
MSModesar Shakoor
Modesar Shakoor
PBPierre Beauchêne
Pierre Beauchêne
Chung-Hae ParkChung-Hae Park
Chung-Hae Park
A numerical analysis of the influence of race tracking on dry spots formation and the accuracy of permeability measurement during the resin-transfer-molding process is presented. In the numerical simulation of the mold-filling process, defects are randomly generated, and their effect is assessed by a Monte Carlo simulation method. The effect of race tracking on the unsaturated permeability measurement and dry spots formation is investigated on flat plates. It is observed that the race-tracking defects located near the injection gate increase up to 40% of the value of the measured unsaturated permeability. The race-tracking defects located near the air vents are more likely to generate dry spots, whereas those near the injection gates have a less significant influence on dry spots generation. Depending on vent location, it has for instance been shown that the dry spot area can increase by a factor of 30. Dry spots may be mitigated by placing an air vent at a suitable location based on the numerical analysis results. Moreover, those results may be helpful to determine optimal sensor locations for the on-line control of mold-filling processes. Finally, the approach is successfully applied to a complex geometry.

12 April 2023 in Materials
Verified
Journal Article
Open access
PDF file
NKNina Kergosien
Nina Kergosien
LUDOVIC GAVERINALUDOVIC GAVERINA
LUDOVIC GAVERINA
GRGuillemette Ribay
Guillemette Ribay
FSFlorence Saffar
Florence Saffar
PBPierre Beauchêne
Pierre Beauchêne
OBOlivier Bareille
Olivier Bareille
In the context of an embedded structural health monitoring (SHM) system, two methods of transducer integration into the core of a laminate carbon fiber-reinforced polymer (CFRP) are tested: cut-out and between two plies. This study focuses on the effect of integration methods on Lamb wave generation. For this purpose, plates with an embedded lead zirconate titanate (PZT) transducer are cured in an autoclave. The embedded PZT insulation, integrity, and ability to generate Lamb waves are checked with electromechanical impedance, X-rays, and laser Doppler vibrometry (LDV) measurements. Lamb wave dispersion curves are computed by LDV using two-dimensional fast Fourier transform (Bi-FFT) to study the quasi-antisymmetric mode (qA0) excitability in generation with the embedded PZT in the frequency range of 30 to 200 kHz. The embedded PZT is able to generate Lamb waves, which validate the integration procedure. The first minimum frequency of the embedded PZT shifts to lower frequencies and its amplitude is reduced compared to a surface-mounted PZT.