In the current research, magnesium and its alloys have been intensively studied as resorbable implant materials. Magnesium materials combine their good mechanical properties with bioactivity, which make them interesting for guided bone regeneration and for the application as barrier membranes. In this study, the in vitro degradation behavior of thin magnesium films was investigated in cell medium and simulated body fluid. Three methods were applied to evaluate corrosion rates: measurements of (i) the gaseous volume evolved during immersion, (ii) volume change after immersion, and (iii) polarization curves. In this comparison, measurements of H2 development in Dulbecco's modified Eagle's medium showed to be the most appropriate method, exhibiting a corrosion rate of 0.5 mm·year−1. Observed oxide and carbon contamination have a high impact on controlled degradation, suggesting that surface treatment of thin foils is necessary. The bioactivity test showed positive results; more detailed tests in this area are of interest.
Osteoarthritis (OA) is a degenerative joint disease causing loss of articular cartilage and structural damage in all joint tissues. Given the limited regenerative capacity of articular cartilage, methods to support the native structural properties of articular cartilage are highly anticipated. The aim of this study was to infiltrate zwitterionic monomer solutions into human OA-cartilage explants to replace lost proteoglycans. The study included polymerization and deposition of methacryloyloxyethyl-phosphorylcholine- and a novel sulfobetaine-methacrylate-based monomer solution within ex vivo human OA-cartilage explants and the encapsulation of isolated chondrocytes within hydrogels and the corresponding effects on chondrocyte viability. The results demonstrated that zwitterionic cartilage–hydrogel networks are formed by infiltration. In general, cytotoxic effects of the monomer solutions were observed, as was a time-dependent infiltration behavior into the tissue accompanied by increasing cell death and penetration depth. The successful deposition of zwitterionic hydrogels within OA cartilage identifies the infiltration method as a potential future therapeutic option for the repair/replacement of OA-cartilage extracellular suprastructure. Due to the toxic effects of the monomer solutions, the focus should be on sealing the OA-cartilage surface, instead of complete infiltration. An alternative treatment option for focal cartilage defects could be the usage of monomer solutions, especially the novel generated sulfobetaine-methacrylate-based monomer solution, as bionic for cell-based 3D bioprintable hydrogels.
Electropolishing magnesium materials is challenging due to the strong susceptibility of magnesium to corrosion in aqueous electrolytes. Deep eutectic solvents (DES) represent a less aggressive alternative, but their electrochemical behavior toward magnesium is not well understood. In this study, Ethaline, Glyceline and Reline were systematically investigated as electrolytes for the electropolishing of a magnesium material. The process parameters from traditional phosphoric acid systems were adapted and optimized to DES regarding electrolyte temperature and agitation as well as specimen position and orientation. Electropolishing was conducted at 1700 mV vs. Ag/AgCl (3M) and 18 C/cm², employing elevated temperature (80°C), rapid stirring of the electrolyte and positioning the sample surface perpendicular to the electrolyte flow with repeated 180° specimen rotation. The optimized DES systems produced smooth, mirror-like, nearly defect-free and corrosion-resistant surfaces comparable to those obtained with acidic electrolytes. Additionally, DES enabled high-purity surfaces, reduced polishing times, and excellent reproducibility. Ethaline achieved the best surface quality despite strong driving forces for anodic film formation, whereas Glyceline and Reline showed promising results for further optimization. The findings reveal new insights into the anodic behavior of magnesium in DES and establish them as viable electrolytes for sustainable and high-performance electropolishing of magnesium materials.