George Gorgolis

Dr. George Gorgolis


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
4 August 2022 in Nanomaterials
Verified
Journal Article
Open access
PDF file
GPGeorge Paterakis
George Paterakis
EVEoghan Vaughan
Eoghan Vaughan
DGDinesh R. Gawade
Dinesh R. Gawade
RMRichard Murray
Richard Murray
GGGeorge Gorgolis
George Gorgolis
CGCostas Galiotis
Costas Galiotis
Ultra-sensitive and responsive humidity sensors were fabricated by deposition of graphene oxide (GO) on laser-induced graphene (LIG) electrodes fabricated by a low-cost visible laser scribing tool. The effects of GO layer thickness and electrode geometry were investigated. Sensors comprising 0.33 mg/mL GO drop-deposited on spiral LIG electrodes exhibited high sensitivity up to 1800 pF/% RH at 22 °C, which is higher than previously reported LIG/GO sensors. The high performance was ascribed to the high density of the hydroxyl groups of GO, promoted by post-synthesis sonication treatment, resulting in high water physisorption rates. As a result, the sensors also displayed good stability and short response/recovery times across a wide tested range of 0–97% RH. The fabricated sensors were benchmarked against commercial humidity sensors and displayed comparable performance and stability. Finally, the sensors were integrated with a near-field communication tag to function as a wireless, battery-less humidity sensor platform for easy read-out of environmental humidity values using smartphones.

5 April 2024 in Scientific Reports
Verified
Journal Article
Open access
PDF file
GGGeorge Gorgolis
George Gorgolis
MKM. Kotsidi
M. Kotsidi
GPG. Paterakis
G. Paterakis
NKN. Koutroumanis
N. Koutroumanis
CTC. Tsakonas
C. Tsakonas
CGCostas Galiotis
Costas Galiotis
Environmental accidents highlight the need for the development of efficient materials that can be employed to eliminate pollutants including crude oil and its derivatives, as well as toxic organic solvents. In recent years, a wide variety of advanced materials has been investigated to assist in the purification process of environmentally compromised regions, with the principal contestants being graphene-based structures. This study describes the synthesis of graphene aerogels with two methods and determines their efficiency as adsorbents of several water pollutants. The main difference between the two synthesis routes is the use of freeze-drying in the first case, and ambient pressure drying in the latter. Raman spectroscopy, Scanning Electron Microscopy (SEM), X-ray diffraction (XRD), X-ray Photoelectron Spectroscopy (XPS) and contact angle measurements are employed here for the characterisation of the samples. The as-prepared aerogels have been found to act as photocatalysts of aqueous dye solutions like methylene blue and Orange G, while they were also evaluated as adsorbents of organic solvents (acetone, ethanol and methanol), and, oils like pump oil, castor oil, silicone oil, as well. The results presented here show that the freeze-drying approach provides materials with better adsorption efficiency for the most of the examined pollutants, however, the energy and cost-saving advantages of ambient-pressure-drying could offset the adsorption advantages of the former case.

4 May 2023 in Materials
Verified
Journal Article
Open access
PDF file
GGGeorge Gorgolis
George Gorgolis
SZSteffen Ziemann
Steffen Ziemann
MKMaria Kotsidi
Maria Kotsidi
GPGeorge Paterakis
George Paterakis
NKNikos Koutroumanis
Nikos Koutroumanis
CGCostas Galiotis
Costas Galiotis
The very serious problem of temperature and humidity regulation, especially for small and medium-sized museums, galleries, and private collections, can be mitigated by the introduction of novel materials that are easily applicable and of low cost. Within this study, archive boxes with innovative technology are proposed as “smart” boxes that can be used for storage and transportation, in combination with a nanocomposite material consisting of polyvinyl alcohol (PVA) and graphene oxide (GO). The synthesis and characterization of the PVA/GO structure with SEM, Raman, AFM, XRD, Optical Microscopy, and profilometry are fully discussed. It is shown that the composite material can be integrated into the archive box either as a stand-alone film or attached onto fitting carriers, for example, those made of corrugated board. By applying the PVA/GO membrane this way, even with strong daily temperature fluctuations of ΔT = ±24.1 °C, strong external humidity fluctuations can be reduced by −87% inside the box. Furthermore, these humidity regulators were examined as Volatile Organic Compounds (VOCs) adsorbers since gas pollutants like formic acid, formaldehyde, acetic acid, and acetaldehyde are known to exist in museums and induce damages in the displayed or stored items. High rates of VOC adsorption have been measured, with the highest ones corresponding to formic acid (521% weight increase) and formaldehyde (223% weight increase).

28 June 2024 in Materials
Verified
Journal Article
Open access
PDF file
GGGeorge Gorgolis
George Gorgolis
MKMaria Kotsidi
Maria Kotsidi
EMElena Messina
Elena Messina
VMValentina mazzurco miritana
Valentina mazzurco miritana
GCGabriella Di Carlo
Gabriella Di Carlo
CGCostas Galiotis
Costas Galiotis
The use and integration of novel materials are increasingly becoming vital tools in the field of preventive conservation of cultural heritage. Chemical factors, such as volatile organic compounds (VOCs), but also environmental factors such as high relative humidity, can lead to degradation, oxidation, yellowing, and fading of the works of art. To prevent these phenomena, highly porous materials have been developed for the absorption of VOCs and for controlling the relative humidity. In this work, graphene and transition-metal dichalcogenides (TMDs) were combined to create three-dimensional aerogels that absorb certain harmful substances. More specifically, the addition of the TMDs molybdenum disulfide and tungsten disulfide in such macrostructures led to the selective absorption of ammonia. Moreover, the addition of the ionic liquid 1-hexadecyl-3-methylimidazolium chloride promoted higher rates of VOCs absorption and anti-fungal activity against the fungus Aspergillus niger. These two-dimensional materials outperform benchmark porous absorbers in the absorption of all the examined VOCs, such as ammonia, formic acid, acetic acid, formaldehyde, and acetaldehyde. Consequently, they can be used by museums, galleries, or even storage places for the perpetual protection of works of art.

9 March 2026 in Scientific Reports
Verified
Journal Article
Open access
GGGeorge Gorgolis
George Gorgolis
NPNatalia Pastra
Natalia Pastra
GPGeorge Paterakis
George Paterakis
NKNikos Koutroumanis
Nikos Koutroumanis
CTChristos Tsakonas
Christos Tsakonas
CGCostas Galiotis
Costas Galiotis