This article discusses the issue of force behavior in a pre-tensioned bolt that is part of a symmetrical flange connection, loaded with an operating load parallel to the bolt axis. The first part describes the issue being dealt with in detail. The next part offers a brief description of the generally known theoretical approach to the solution, and also outlines the limitations of this approach. This part is followed by a theoretical analysis of working load behavior in the bolt of the analyzed device, using Finite Element Method (FEM). In this article, a comparison of several different approaches to the solution can be also found, followed by a description of the experiment preparation and its results. The obtained values also serve as a subject for reverse iterative analysis carried out using ANSYS software. The aim is to find a proper modification to the symmetric calculation model that would be consistent with the results of measurements from technical practice. All results achieved are described in the final part of the article.
The paper presents a construction design and results of laboratory tests of so-called mechanical stress detectors, which can be used to detect the deformation of the steel structure of a crane and to amplify the mechanical signal from the effect of the so-called crane skewing, which is included a...
The MM Science Journal, published since 2008, is a world respected scientific journal. The journal, published in English, is double peer reviewed and competitive in distributing knowledge among domestic and international academics and professionals. Full texts are available on-line on the journal...
This study describes the statistical analysis of peak forces of industrial washing machines. The data source comes from twelve different machines. The measurements are done using a force gauge installed in places for fastening screws. A new software based on LabView has been developed to gauge the acting forces. To determine extreme force values, various probability distributions are applied. Furthermore, a convex combination of lognormal distribution is used in more complicated cases. The parameters of the lognormal mixtures are determined using modified an Expectation-maximization algorithm. Finally, the achieved results are interpreted with regard to the engineering design and to the operating reliability.