Most methods for state-of-charge or state-of-health prognostics are impedance based. Impedance models must be as simple as possible to be implemented on embedded applications but as accurate as possible to represent the main electrochemical phenomena. The parameters of such models can be identified using impedance spectroscopy. However, the electrochemical features change in relation to numerous parameters, such as temperature or aging, which involves updating the model of the battery online. This paper deals with the use of an extended Kalman filter (EKF) for the observation of the parameters of a Li-ion battery lumped model. First, this paper will focus on the electrical model that can be used to represent the main electrochemical phenomena in the battery. Then, mathematical considerations about the EKF are reminded to be applied to the observation of the impedance parameters of the battery. This method has been validated on an urban driving cycle of a hybrid electric vehicle.
3 January 2020 in IEEE Transactions on Industrial Electronics
Synchronous reluctance machine (SynRM) has been studied widely in order to reduce its high torque ripple and improve its low power factor. This paper proposes a torque ripple reduction method for SynRM by defining a novel parameter-torque function. With the help of torque function, the optimal currents aiming to compensate torque harmonics are obtained. The advantage of the proposed method is that torque function can be obtained easily and torque ripple reduction can be achieved by a simple control method. For the purpose of verifying the proposed method, both simulations and experiments are performed. At last, the influence of power supply and parameter uncertainty on the proposed method has also been discussed.
29 August 2017 in IEEE Transactions on Industry Applications
This paper presents a systematic procedure to study the impact of each thermal phenomenon occurring in electric machines on their internal temperature distribution. First, the Monte-Carlo method is chosen as a global sensitivity analysis technique. This method is applied on a thermal network of a prototype consisting of a permanent magnet based integrated starter-generator machine. Accordingly, the variation of electric machine critical temperatures in windings and rotor's permanent magnets is evaluated. In addition, a sensitivity index is defined for identifying network parameters that cause significant variation on the machine critical temperatures and should therefore be the focus of attention when designing electric machines. Finally, experimental tests are performed on the prototype, and the deviation between simulated and measured temperatures is presented.
26 November 2020 in IEEE Transactions on Industry Applications
Embedded applications like electric and hybrid vehicles are increasingly using electrical machines with a very high power / mass ratio. In this context, the design of such machines, very often operating at high speeds, becomes essential. However, in order to remain economically attractive, these machines cannot use rare earth magnets but at best include (low cost) ferrites. In this context, a significant number of publications have shown that reluctance synchronous reluctance machine (SynRM) may be a good choice. However, this type of machine gives poor performances due to the difficulty to get high saliency ratio. This saliency ratio may be improved by the use of low cost ferrites. The determination of the height of the magnetic bridges becomes then a problem of the prime importance to ensure both high-speed integrity and high saliency ratio. This paper proposes a fast model based on the Beam Theory Method (BTM) which is intended to be integrated in an electromechanical optimization process. This method will be compared to another one that has been previously introduced for this type of problem: the Equivalent Ring Method. The maximum mechanical stress at critical regions of the rotor of the assisted synchronous reluctance machine can then be calculated for different rotating speeds and rotor iron bridge thicknesses. By adopting the concept of stress concentration, both methods are compared with the results of finite element analyses. Finally, a prototype of the assisted synchronous reluctance machine is used to validate these results from finite element simulations.