The interest in seaweeds for cosmetic, cosmeceutics, and nutricosmetics is increasing based on the demand for natural ingredients. Seaweeds offer advantages in relation to their renewable character, wide distribution, and the richness and versatility of their valuable bioactive compounds, which can be used as ingredients, as additives, and as active agents in the formulation of skin care products. Bioactive compounds, such as polyphenols, polysaccharides, proteins, peptides, amino acids, lipids, vitamins, and minerals, are responsible for the biological properties associated with seaweeds. Seaweed fractions can also offer technical features, such as thickening, gelling, emulsifying, texturizing, or moistening to develop cohesive matrices. Furthermore, the possibility of valorizing industrial waste streams and algal blooms makes them an attractive, low cost, raw and renewable material. This review presents an updated summary of the activities of different seaweed compounds and fractions based on scientific and patent literature.

The waste solids remaining after the ethanolic extraction of arnica were proposed as raw material for the recovery of the remaining phenolic fraction. Greener processes based on intensification extraction, with microwave (MHG) and ultrasound (UAE) assistance and pressurized hot water extraction under subcritical conditions (AH), were studied. The entire process provided approximately 28% of phenolics for the sequence when MHG was used, 22% in the sequence where AH was employed, and the extracts showed up to 60% the ABTS radical scavenging capacity of Trolox. However, the cytotoxic effects on the cell growth of tumoral cells were only moderate. Therefore, considering a possible external topical application, extracts containing selected arnica extracts were further used to develop polymer-based gelled matrices formulated with either chitosan or polyvinyl alcohol. Rheological testing indicated that all proposed matrices exhibited relatively high mechanical features, even better than those determined with matrices prepared with their counterpart commercial arnica tinctures. Overall, the shear-thinning behavior of gelled matrices loaded with arnica extracts obtained by MHG or AH stages was enhanced compared to those containing ethanolic extracts, whereas the viscoelastic features became smoother for polymeric matrices incorporated with arnica extracts recovered at the highest MHG irradiation powers or at the highest set point temperatures of AH treatments.

Aristotelia chilensis is a plant rich in phenolics and other bioactive compounds. Their leaves are discarded as waste in the maqui berry industry. A new application of these wastes is intended by the recovery of bioactive compounds using pressurized hot water extraction with conventional or microwave heating. Both technologies have been selected for their green character regarding the type of solvent and the high efficiency in shorter operation times. Extractions were performed in the temperature range 140–200 °C with a solid/liquid ratio of 1:15 (w:w). The extracts’ total phenolic content, antioxidant capacity, and saccharides content obtained with both heating methods were measured. Additionally, the thermo-rheological properties of the gelling matrix enriched with these extracts were analyzed. Optimum conditions for lyophilized extracts were found with conventional heating, at 140 °C and 20 min extraction; 250.0 mg GAE/g dry extract and 1321.5 mg Trolox/g dry extract. Close to optimum performance was achieved with microwave heating in a fraction of the time (5 min) at 160 °C (extraction), yielding extracts with 231.9 mg GAE/g dry extract of total phenolics and antiradical capacity equivalent to 1176.3 mg Trolox/g dry extract. Slightly higher antioxidant values were identified for spray-dried extracts (between 5% for phenolic content and 2.5% for antioxidant capacity). The extracts obtained with both heating methods at 200 °C contained more than 20% oligosaccharides, primarily glucose. All the formulated gelling matrices enriched with the obtained extracts displayed intermediate gel strength properties. The tested technologies efficiently recovered highly active antioxidant extracts, rich in polyphenolics, and valuable for formulating gelling matrices with potential applicability in foods and other products.