A full-scale 3D numerical model using the discrete element method is used to investigate three different chute designs for the charging of a blast furnace. The three chutes differ in the proportion of the chute that is either smooth or contains rock boxes. The uniformity of the delivery of burden materials is assessed as the burden passes through a 2D plane is used to determine the relative merits of the three designs. The chute composed entirely of rock boxes was predicted to provide the most homogeneous delivery of material to the top of the blast furnace according to the above criterion. Choice of chute design is discussed with reference to the historical movement away from the older ledge-charging strategies to the more modern chimney-charging strategies. Schematic diagram showing predicted burden delivery distribution form a full-scale 3D DEM model for a blast furnace. GRAPHICAL ABSTRACT
Ceramics are considered to be candidate materials for galvanising pot bearing materials due to their excellent corrosion resistance in many molten metals. Galvanising pot roll bearings must have excellent wear resistance, and, therefore, it is important to understand the wear behaviour of prospective bearing materials. This study investigates the friction- and wear-resistant properties of select ceramics, namely, pure hBN, BN M26, AlN-BN, Macor, 3YSZ, Al2O3 and Si3N4. The ceramics were tested at different sliding speeds using a pin-on-disc device equipped with SiC pins. The lowest coefficient of friction (COF) achieved was below 0.1, and it was measured for pure hBN at a 3.14 m/min sliding speed. However, a wear scar analysis showed that the BN grades suffered from severe wear. The highest wear rate was obtained for BN M26 at a 9.42 m/min sliding speed and was equal to 17.1 × 10−6 mm3 N−1 m−1. It was shown that the wear coefficient of the tested ceramics varied exponentially with hardness. The lowest wear was observed on the 3YSZ, Al2O3 and Si3N4 ceramics, which showed no volume loss, and, for this reason, they can be potentially used as bearing materials in continuous galvanising lines.