Straw returning has shown great advantages in residue management and soil protection in crop planting systems. Mechanized retention of straw is the primary straw returning method, which can reduce costs and improve efficiency. It is important to increase the chopping quality in the field of straw returning, because poor chopping quality will provoke a series of problems including seeding blockage. Straw chopping pass rate (CPR) is an important indicator to measure the chopping quality. Therefore, the CPR of straw should be improved during the chopping process. This paper introduced a novel maize straw chopping device. With the ground as the support, the maize straw was chopped rapidly in the vertical direction. The key parameters of the chopping device were determined by establishing mathematical models and kinematics simulation analysis methods via ADAMS. The effects of rotational velocity, installation positions of chopping units, and the tractor forward velocity on the CPR of maize straw and soil bulk density (SBD) were examined through the Box–Behnken design method. The test factors were the rotational velocities of the chopping units (RV, 550 rpm, 650 rpm, 750 rpm), the installation distance of the two chopping units (IDTCU, 480 mm, 600 mm, 720 mm), and the velocity of the tractor (VT, 3 km/h, 4 km/h, 5 km/h). The results showed that the maximum CPR value and better value of SBD were obtained under the RV of 610 rpm, the IDTCU of 526.8 mm, and the VT of 3.96 km/h. Finally, field validation experiments were conducted under the RV of 610 rpm, the IDTCU of 550 mm, and the VT of 4 km/h. The results showed that the CPR of maize straw was 92.0%, which was superior to the requirement as stipulated in the National Standards of China (CPR ≥ 85%). In addition, in 0–50 mm and 50–100 mm soil layers, the bulk density was decreased by 25.42% and 13.24%, respectively. These results become of considerable importance for crop production in China.

Precision seeding is an effective technical way to improve quality and reduce material costs. However, certain factors limit the development and promotion of precision seeding technology, among which the main factor is that the agronomic requirements of sowing vary significantly in different areas, and there is a lack of suitable implements; at the same time, each link among the parts interact, which brings specific difficulties to improving the operational effect. This paper summarizes the precision seeding technology from the perspective of precision seeding realization and the consistency of seed spacing and use of consistent sowing depth control technology. A detailed description is included of the precision seed-discharge technology, the smooth seed-dropping technology, and the seed falling into the seed bed with precision. The need for regulation technology for consistent sowing depth is explained from a developmental perspective. The research status of compatible sowing depth control technology is described, as used in soil covering and compacting. This paper presents the problems and future development directions of soil-covering and compacting technology under precision-seeding conditions, including developing adaptable regional soil-covering and compacting devices, improving the processing and equipment technology of enterprises, strengthening the structural optimization design of soil-covering and compacting devices, conducting research into soil-covering and compacting control methods, and promoting the intellectual development of agricultural equipment.