In general, groundwater flow and transport models are being applied to investigate a wide variety of hydrogeological conditions besides to calculate the rate and direction of movement of groundwater through aquifers and confining units in the subsurface. Transport models estimate the concentration of a chemical in groundwater which requires the development of a calibrated groundwater flow model or, at a minimum, an accurate determination of the velocity and direction of groundwater flow that is based on field data. All the available hydrogeological, geophysical and water quality data in Musi basin, Hyderabad, India, were fed as input to the model to obtain the groundwater flow velocities and the interaction of surface water and groundwater and thereby seepage loss was estimated. This in turn paved the way to calculate the capacity of the storage treatment plants (STP) to be established at the inlets of six major lakes of the basin. The total dissolved solid was given as the pollutant load in the mass transport model, and through model simulation, its migration at present and futuristic scenarios was brought out by groundwater flow and mass transport modeling. The average groundwater velocity estimated through the flow model was 0.26 m/day. The capacities of STP of various lakes in the study area were estimated based on the lake seepage and evaporation loss. Based on the groundwater velocity and TDS as pollutant load in the lakes, the likely contamination from lakes at present and for the next 20 years was predicted.
1 May 2019 in Journal of the Geological Society of India
Shear-wave velocity-depth information plays a significant role in assessing earthquake hazard of any region. Further, it is required for most investigations of ground motion response to earthquakes in areas where significant soil cover exists. The thickness and velocity of geologic formations are the vital parameters above the bedrock that affect the frequency band of the ground motion that may be strongly amplified by the local site conditions. In view of this, shear-wave velocity assumes great importance in earthquake hazard assessment studies. The characteristics of shear-wave velocity profile were determined by multichannel analysis of surface waves (MASW) technique in as many as 99 sites over different geological units in parts of Muscat city in order to evaluate probable hazard if any. The variations of shear wave velocity down to depths of 5 m, 10 m, 15 m and 30 m, respectively are presented. However, the average shear wave velocities calculated down to a depth of 30 m (VS30) vary between 345 m/s and 1197 m/s. The high range of shear-wave velocity almost rules out the liquefaction potential due to earthquakes of moderate to high magnitude.