Different commercial reverse osmosis (RO) membranes from Vontron and DuPont Filmtec were evaluated for textile dyeing and finishing wastewater (TDFW) reuse in China. All six tested RO membranes produced qualified permeate meeting TDFW reuse standards at a water recovery ratio (WRR) of 70% in single batch tests. The rapid decline of apparent specific flux at WRR over 50% was mainly ascribed to feed osmotic pressure increase caused by concentrating effects. Multiple batch tests using Vontron HOR and DuPont Filmtec BW RO membranes with comparable permeability and selectivity demonstrated the reproducibility and showed low fouling development. The occurrence of carbonate scaling on both RO membranes was identified by scanning electron microscopy and energy disperse spectroscopy. No obvious organic fouling was detected on both RO membranes by attenuated total reflectance Fourier transform infrared spectrometry. From the orthogonal tests, with an integrated RO membrane performance index (i.e., 25% rejection ratio of total organic carbon + 25% rejection ratio of conductivity + 50% flux ratio of final to initial) as a target, the optimal parameters were determined as WRR of 60%, cross-flow velocity (CFV) of 1.0 m/s, temperature (T) of 20 °C for both RO membranes, while trans-membrane pressures (TMP) of 2 and 4 MPa were optimal for Vontron HOR RO membrane and DuPont Filmtec BW RO membrane, respectively. Both RO membranes with the optimal parameters produced good permeate quality for TDFW reuse and kept a high flux ratio of final to initial, demonstrating the effectiveness of the orthogonal tests.
Reverse osmosis (RO) is the key process for textile dyeing wastewater reuse applications. Membrane fouling reduces both permeability and rejection capability, negatively affecting the technological economy of RO process. Membrane cleaning is critical to recovery of the permeability of fouled RO membranes. Based on multi-batch filtration and cleaning experiments, this study systematically evaluated the RO membrane fouling potential of pre-treated textile dyeing wastewater by a membrane bioreactor and the recovery performance of fouled RO membranes after different cleaning methods. A significant decline (more than 15%) in RO membrane permeability occurred after RO membrane permeate production of 625 L/m2 at a water recovery ratio of 60%. Protein-like substances and soluble microbial products were identified as the primary organic foulants via three-dimensional fluorescence excitation-emission matrix spectrometry (3D-FEEM). The single forward flushing with either pure water, acid, alkaline, or sodium hypochlorite solutions with a low active chlorine concentration showed very limited recovery of fouled RO membrane permeability. The combined forward flushing with acid followed by alkaline solutions restored fouled membrane permeability by up to 87% of a new RO membrane. The addition of pure water backwashing at a transmembrane pressure (TMP) of 0.5 MPa after both acid and alkaline solutions combined forward flushing restored fouled membrane permeability by up to 97% of a new RO membrane but deteriorated the rejection capability of the RO membrane. The backwashing parameters were further optimized at a TMP of 0.125 MPa and crossflow velocity (CFV) of 0.5 m/s, achieving fouled RO membrane permeability by up to 96% of a new RO membrane, and there were no negative effects on the rejection capability of the RO membrane. Alkaline forward flushing followed by pure water backwashing was the dominant contributor for fouled RO membrane permeability recovery. A preliminary economic analysis showed that the total chemical cost per RO production was 0.763 CNY/m3 and could be further reduced via removing acid cleaning and replacing combined alkaline flushing and pure water backwashing with alkaline backwashing.
Rising multidrug-resistant (MDR) bacteria threatens global public health. While antibiotic selection preserves MDR plasmids, how mobile genetic elements (MGEs) drive the antibiotic resistance gene (ARG) accumulation to form complex plasmid architectures remain elusive. Here, we demonstrate that MDR plasmid evolution follows a hierarchical scheme, where progressive combinations of integrons, IS26, and ISCR elements drive stepwise increases in ARG load. The combination of all these three MGEs were significantly linked to the highest ARG load on plasmids. In the presence of integrons or ISCR elements, ARG numbers in plasmids are strongly and positively correlated with IS26 copy numbers. Such correlations were further validated by Escherichia coli plasmids collected from human and pig wastewater. We propose an integron-IS26-ISCR (3I) framework with four MDR plasmid evolutionary stages of increasing ARG accumulation potential. The “3I” framework refines predictions of MDR plasmid emergence and spread, providing universal genetic markers for cost-effective surveillance.
Desalination of hypersaline brines is garnering increasing interest, which demands novel technologies. To this effect, we report a comprehensive autopsy of pilot-scale ultra-high pressure reverse osmosis (UHPRO) membranes operated in batch mode harvested from a produced water beneficial reuse treatment plant in the Permian Basin, Texas. Physical-chemical alterations of membranes due to operation at 1,650 psi, including dissimilar embossment behavior on either side of the permeate spacer, were diagnosed. On one side, the ridge and valley morphology created by the knitted spacer filaments caused inelastic wavelike membrane deformation. On the other side, spacer filaments were in-plane with each other, which only embossed membranes and did not cause substantial or permanent deformation. Scalants appeared to be preferentially accumulated alongside imprints, suggesting this was an artifact of membrane deformation. In extreme cases, the membranes even developed microcracks. Inorganic scaling and (bio)organic fouling were low, which was attributed to effective pretreatment and judicious UHPRO operation. Aluminosilicates were the dominant inorganic scale, and iodine was evenly distributed across the membrane surfaces. Low amounts of chromium, calcium, magnesium, barium, and iron were heterogeneously deposited across the membranes. Results pointed to the need to develop novel spacers and membrane polymers and to update concentration polarization models, accounting for potential flow heterogeneities introduced by embossment.
Based on multi-batch filtration and cleaning experiments, this study systematically evaluated the fouling potential of pre-treated textile dyeing wastewater by membrane bioreactor on reverse osmosis (RO) membranes and the recovery performance of fouled RO membranes after different cleaning methods. After a permeate production of 625 L/m², continuous foulants accumulation resulted in a significant decline in RO membrane permeability. Protein-like substances and sol-uble microbial products were identified as the primary organic foulants via three-dimensional fluorescence excitation-emission matrix spectrometry (3D-FEEM). The single forward flushing with pure water, acid solution (pH 3.5), alkaline solution (pH 10.5), and sodium hypochlorite with low effective chlorine concentration (1-2 mg/L) showed very limited recovery of fouled RO membrane permeability. The combined forward flushing with acid solution (pH 2) followed by alkaline solution (pH 11.5) restored fouled membrane permeability up to 87% of new RO mem-brane. The addition of pure water backwashing at transmembrane pressure of 0.5 MPa after both acid and alkaline combined forward flushing restored fouled membrane permeability up to 97% of new RO membrane but deteriorated the rejection capacity of RO membrane. The backwashing parameters were further optimized as transmembrane pressure of 0.5 MPa and crossflow veloci-ty of 0.5 m/s, achieving fouled membrane permeability up to 96% of new RO membrane and no negative effects on the rejection capacity of RO membrane. Therefore, the combined cleaning of acid forward flushing → pure water backwashing → alkaline forward flushing → pure water backwashing was proposed for RO membrane cleaning from textile dyeing wastewater reuse application.