Małgorzata Kot

Dr. Małgorzata Kot

orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 December 2016 in ChemSusChem
Verified
Journal Article
Closed access
PDF file
MKMałgorzata Kot
Małgorzata Kot
CDChittaranjan Das
Chittaranjan Das
ZWZhiping Wang
Zhiping Wang
KHKarsten Henkel
Karsten Henkel
ZRZied Rouissi
Zied Rouissi
DSDieter Schmeisser
Dieter Schmeisser

26 September 2018 in ChemSusChem
Verified
Journal Article
Closed access
PDF file
MKMałgorzata Kot
Małgorzata Kot
LKLukas Kegelmann
Lukas Kegelmann
CDChittaranjan Das
Chittaranjan Das
PKPeter Kus
Peter Kus
NTNataliya Tsud
Nataliya Tsud
DSDieter Schmeisser
Dieter Schmeisser

19 May 2023 in Materials
Verified
Journal Article
Open access
PDF file
Michal MazurMichal Mazur
Michal Mazur
PKPaulina Kapuścik
Paulina Kapuścik
WWWiktoria Weichbrodt
Wiktoria Weichbrodt
JDJaroslaw Domaradzki
Jaroslaw Domaradzki
PMPiotr Mazur
Piotr Mazur
JFJan Ingo Flege
Jan Ingo Flege
Hydrogen gas sensors have recently attracted increased interest due to the explosive nature of H2 and its strategic importance in the sustainable global energy system. In this paper, the tungsten oxide thin films deposited by innovative gas impulse magnetron sputtering have been investigated in terms of their response to H2. It was found that the most favourable annealing temperature in terms of sensor response value, as well as response and recovery times, was achieved at 673 K. This annealing process caused a change in the WO3 cross-section morphology from a featureless and homogenous form to a rather columnar one, but still maintaining the same surface homogeneity. In addition to that, the full-phase transition from an amorphous to nanocrystalline form occurred with a crystallite size of 23 nm. It was found that the sensor response to only 25 ppm of H2 was equal to 6.3, which is one of the best results presented in the literature so far of WO3 optical gas sensors based on a gasochromic effect. Moreover, the results of the gasochromic effect were correlated with the changes in the extinction coefficient and the concentration of the free charge carriers, which is also a novel approach to the understanding of the gasochromic phenomenon.

12 March 2025 in Energy & Environmental Science
Verified
Journal Article
Open access
PDF file
MKMayank Kedia
Mayank Kedia
CDChittaranjan Das
Chittaranjan Das
MKMałgorzata Kot
Małgorzata Kot
YYYenal Yalcinkaya
Yenal Yalcinkaya
WZWeiwei Zuo
Weiwei Zuo
MSMichael Saliba
Michael Saliba
Atomic layer deposition of aluminum oxide (ALD-Al2O3) layers has been extensively studied for stabilizing perovskite solar cells (PSCs) against environmental stressors, such as humidity and oxygen. In addition, the ALD-Al2O3 layer acts as a protective barrier, mitigating the pernicious halide ion migration from the perovskite toward the hole transport interface. However, its effectiveness in preventing the infiltration of ions and additives from the hole-transport layer into perovskites remains insufficiently understood. Herein, we demonstrate the deposition of a compact ultrathin (~0.75 nm) ALD-Al2O3 layer that conformally follows the morphology of a triple-cation perovskite film over a large area. This promotes effective mechanical adhesion of the spiro-OMeTAD layer on top of the perovskite, thereby improving the charge carrier collection between these two layers. Upon systematically investigating the layer-by-layer structure of the PSC stack, we discovered that ALD-Al2O3 also acts as a diffusion barrier for the degraded species from the adjacent transport layer into the perovskite. In addition to all protection capabilities, ALD-Al2O3 impedes the transition of crystalline perovskites to an undesired amorphous phase instead of a yellow delta phase. Consequently, the dual functionality (i.e., enhanced mechanical adhesion and diffusion barrier) of the ALD-Al2O3 protection enhanced the device performance from 19.1% to 20.5%, retaining 98% of its initial power conversion efficiency compared to <10% for pristine devices after 1500 h of outdoor testing under ambient conditions. Finally, this study deepens our understanding of the mechanism of ALD-Al2O3 as a two-way diffusion barrier, highlighting the multifaceted role of buffer layers in interfacial engineering for the long-term stability of PSCs.

1 August 2019 in Materials & Design
Verified
Journal Article
Open access
AOAgata Obstarczyk
Agata Obstarczyk
DKD. Kaczmarek
D. Kaczmarek
Damian WojcieszakDamian Wojcieszak
Damian Wojcieszak
Michal MazurMichal Mazur
Michal Mazur
JDJaroslaw Domaradzki
Jaroslaw Domaradzki
MKMałgorzata Kot
Małgorzata Kot

16 December 2016 in Journal of Vacuum Science & Technology A
Verified
Journal Article
Closed access
PDF file
KHKarsten Henkel
Karsten Henkel
MKMałgorzata Kot
Małgorzata Kot
DSDieter Schmeißer
Dieter Schmeißer
In this study, the authors compared different Al2O3 films grown by atomic layer deposition (ALD) with the same aluminum precursor but on different substrates. The authors employed different process parameters such as thermal-ALD and plasma-enhanced-ALD using different substrate temperatures ranging from 280 °C down to room temperature. They characterized these films by resonant photoelectron spectroscopy and by electrical measurements. They established that generally the ALD-Al2O3 films show characteristic features of bulk Al2O3. For all films investigated, the authors found intrinsic defect states within the electronic band gap and identified excitonic, polaronic, and charge-transfer defect states. The authors gave an atomistic model to explain these intrinsic defects and found that their relative abundance is subject of the choice of ALD parameters and of the substrate used. They were able to relate the spectroscopic assigned in-gap defect states with the electronic charges as determined in our electrical measurements.