The microstructures induced by the laser-powder bed fusion (L-PBF) process have been widely investigated over the last decade, especially on austenitic stainless steels (AISI 316L) and nickel-based superalloys (Inconel 718, Inconel 625). However, the conditions required to initiate recrystallization of L-PBF samples at high temperatures require further investigation, especially regarding the physical origins of substructures (dislocation densities) induced by the L-PBF process. Indeed, the recrystallization widely depends on the specimen substructure, and in the case of the L-PBF process, the substructure is obtained during rapid solidification. In this paper, a comparison is presented between Inconel 625 specimens obtained with different laser-powder bed fusion (L-PBF) conditions. The effects of the energy density (VED) values on as-built and heat-under microstructures are also investigated. It is first shown that L-PBF specimens created with high-energy conditions recrystallize earlier due to a larger density of geometrically necessary dislocations. Moreover, it is shown that lower energy densities offers better tensile properties for as-built specimens. However, an appropriate heat treatment makes it possible to homogenize the tensile properties.
The aim of this work is to present an efficient procedure for growing large metallic single crystals that associates a classical growth technique (namely, the critical strain-annealing—CSA—method) with advanced methods of accurate full-field strain measurements based on digital image correlation (DIC) technique and of sample geometry design using finite element analysis. Measuring the critical plastic strains with an accuracy better than 0.1% resulted in a significantly improved construction of the recrystallization diagram. Applying this “DIC-assisted CSA method” to an A1050 commercially pure aluminum allowed obtaining in less than two days (26 h to 30 h) large multi-crystal samples with a half dozen of large grains. Their length between 35 mm and 100 mm was in full agreement with the obtained recrystallization diagram.