Xiaoliang Wang

Mr. Xiaoliang Wang

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 June 2023 in Sustainability
Verified
Journal Article
Open access
PDF file
XWXiaoliang Wang
Xiaoliang Wang
LHli hongru
li hongru
YZYue Zhong
Yue Zhong
LZLongfei Zhang
Longfei Zhang
XYXi Yang
Xi Yang
ZHZaiqiang Hu
Zaiqiang Hu
The dry-wet cycle is an important factor that causes slope instability and foundation settlement in loess regions. In order to study the effects of the dry-wet cycle on the structure and shear strength of loess, isotropic compression tests and triaxial shear tests were carried out on loess with different numbers of dry-wet cycles. The results show that the dry-wet cycles mainly reduce the cohesion of loess, and the most obvious decline is after the first cycle; however, they have no effect on the angle of internal friction of loess. The structural yield strength and structural parameters of loess can represent the structure of loess well, which gradually decrease with the increase in the number dry-wet cycles and water content. The initial yield surface is approximately an ellipse, which gradually shrinks with the increase in water content and dry-wet cycles. The structure and cohesion of loess have similar changes, and there is an obvious exponential function relationship between them.

1 October 2023 in Materials
Verified
Journal Article
Open access
PDF file
XHxiaoning han
xiaoning han
ZHZaiqiang Hu
Zaiqiang Hu
LYLiangshu Yu
Liangshu Yu
YPYuan Pang
Yuan Pang
HSHaicheng She
Haicheng She
CQChangjun Qi
Changjun Qi
To reveal the dynamic characteristics of asphalt core embankment dams (ACEDs), we carried out a dynamic triaxial experiment on hydraulic asphalt concrete (HAC) under different temperatures (T = 4 °C, 10 °C, 16 °C, and 22 °C) and stress states (Kc = 1.0, 1.2, 1.4, and 1.6; σ3 = 0.5, 0.6, 0.7, and 0.8 MPa). The results indicate that HAC’s maximum dynamic elastic modulus increased with decreasing temperature, increasing principal stress ratio, and increasing confining pressure. However, the damping ratio showed the opposite trend. Moreover, in order to study the deformation capacity of HAC, 300 cyclic loads were applied to some specimens. At a temperature of 22 °C, the specimens had a tendency to deform axially, but not significantly. With a decrease in temperature, the axial deformation tendency of the specimen gradually weakened or even disappeared. However, a small number of cracks appeared in the aggregate and between the asphalt and the aggregate of the specimen. In order to quantify the dependence of dynamic parameters on temperature, the temperature influence factor of the maximum dynamic elastic modulus and the temperature sensing factor of the damping ratio were defined. The variation in the temperature influence factor of the maximum dynamic elastic modulus with temperature can be described by a logistic function. The temperature sensing factor of the damping ratio increased with an increasing principal stress ratio and peripheral pressure. Finally, maximum dynamic elastic modulus and damping ratio computational models for the interaction of temperatures and stress states were developed using the normalization method. Upon comparison, the dynamic parameters were observed to be very close to those listed in the literature, which verifies the applicability of the computational models of the maximum dynamic elastic modulus and damping ratio.

1 January 2024 in Advances in Civil Engineering
Verified
Journal Article
Open access
PDF file
LZLongfei Zhang
Longfei Zhang
ZHZaiqiang Hu
Zaiqiang Hu
LHli hongru
li hongru
HSHaicheng She
Haicheng She
XWXiaoliang Wang
Xiaoliang Wang
XHxiaoning han
xiaoning han
Loess has unique water sensitivity due to its distinct formation environment. The structure of loess is undercompactness, weak cementation, and porousness. The water sensitivity of loess directly leads to many environmental problems and geological hazards, including subgrade subsidences, slope collapse or failures, and building cracking. To reveal the relationship between water sensitivity and loess structure, confined‐compression collapsibility tests and triaxial‐collapsibility tests were performed on loess in different areas. The collapsibility coefficient, porosity ratio, and collapsibility rate were analyzed. Results show that the collapsibility process of loess can be divided into three stages: wetting, softening, and settling. The collapsibility sensitivity of loess is determined primarily by its structural and hydraulic state.

27 October 2023 in Advances in Civil Engineering
Verified
Journal Article
Open access
PDF file
LZLongfei Zhang
Longfei Zhang
ZHZaiqiang Hu
Zaiqiang Hu
LHli hongru
li hongru
HSHaicheng She
Haicheng She
XWXiaoliang Wang
Xiaoliang Wang
XYXi Yang
Xi Yang
The strength of loess in seasonal frozen soil areas decreases evidently due to the freeze-thaw cycle, which even leads to some engineering and geological problems. Fibre reinforcement is very effective in improving the mechanical properties of soil. Triaxial tests under different water contents, freezing temperatures, and number of freeze-thaw cycles were carried out for fibre-reinforced loess to study the ability of fibre reinforcement to improve the resistance of loess to freeze-thaw damage; scanning electron microscopy (SEM) was also conducted. The effects of freeze and thaw deterioration and reinforcement were discussed by comparing the strength parameters under different test conditions, and the influence mechanism of freezing temperature, number of freeze-thaw cycles, and reinforcement on loess strength was explained. Results show that a lower freezing temperature indicates a more evident decrease in strength after thawing. Under the action of the first five freeze-thaw cycles, the degree of decrease is more prominent. The fibre reinforcement can reduce the fragmentation of aggregates in loess, thereby effectively restraining the deterioration effect of loess during freeze-thaw cycles. Finally, the strength parameter prediction model under different freeze-thaw cycles of reinforced loess is established, thereby providing theoretical support for engineering application and numerical simulation of fibre-reinforced loess.

30 June 2023 in Advances in Civil Engineering
Verified
Journal Article
Open access
PDF file
LZLongfei Zhang
Longfei Zhang
ZHZaiqiang Hu
Zaiqiang Hu
LHli hongru
li hongru
HSHaicheng She
Haicheng She
XWXiaoliang Wang
Xiaoliang Wang
XYXi Yang
Xi Yang
With the development of ultrahigh voltage transmission line construction in northwest China, an increasing number of overhead transmission lines are crossing the loess regions. Ensuring the stability of electricity transmission towers and mitigating the risk of collapse are crucial prerequisites for the construction of transmission lines. Taking the 750 kV demonstration electricity transmission line in Guanting–Lanzhou East as an example, representative loess samples were selected for compression and collapsing sensitivity tests. Four foundation treatment schemes were designed, and the wetting deformation characteristics were investigated through numerical simulation of the rainfall infiltration process. Corresponding optimisation schemes were proposed. The collapsing process was divided into four stages through laboratory collapsing tests. The relationship function between saturation and the Duncan–Chang model parameters of loess was established, which was introduced into the finite element model to consider the rainfall infiltration process. The analysis of the displacement field, and loess saturation field with time after rainfall infiltration for the four schemes showed that adding a lime-stabilised soil cushion layer and waterproof layer to the inclined column foundation had the best effect. Given that the design scheme needs to consider safety and economy, the thickness of the cushion layer was optimised, thereby reducing the use of lime-stabilised soil by 20%. Research findings provide meaningful guidance for the design of transmission tower foundations in loess areas.

1 March 2025 in Materials
Verified
Journal Article
Open access
PDF file
XWXiaoliang Wang
Xiaoliang Wang
LHli hongru
li hongru
ZCZhenpeng Chen
Zhenpeng Chen
YZYue Zhong
Yue Zhong
ZHZaiqiang Hu
Zaiqiang Hu
MZMiao zhi Zhang
Miao zhi Zhang
Under undrained monotonic static loading, saturated loose granular materials may undergo static liquefaction. Tailings, a kind of granular material, pose particularly serious hazards after static liquefaction. To understand the effects of the initial state and fines content on the static liquefaction of tailings, consolidated undrained triaxial compression tests and one-dimensional compression tests were carried out on tailings with different initial states and fines content. The critical state strength, undrained shear strength, instability line, brittleness index, and compressibility of tailings were investigated, and the tests results were analyzed and discussed using the critical state framework. The results show that tailings with different initial states have the same critical state line, and changes in fines content will cause the position of the critical state line to shift. An increase in the initial void ratio and initial confining pressure will increase the degree of static liquefaction, while the influence of fines content has a threshold value (30%), at which the degree of static liquefaction is the highest. Our analysis shows that compressibility has limitations for evaluating static liquefaction, while the state parameter is an effective indicator for evaluating the static liquefaction of tailings with different initial states and fines contents. The results provide valuable theoretical and practical insights regarding the static liquefaction of tailings and are of great significance for evaluating the stability and preventing the static instability of tailing dams.