Zaiqiang Hu

Dr. Zaiqiang Hu


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2019 in Mathematical Problems in Engineering
Verified
Journal Article
Open access
PDF file
HSHaicheng She
Haicheng She
ZHZaiqiang Hu
Zaiqiang Hu
ZQZhan Qu
Zhan Qu
HLHongru Li
Hongru Li
HGHu Guo
Hu Guo
XMXiaoli Ma
Xiaoli Ma
Undisturbed loess is affected by external environmental disturbances, such as wetting and freeze‐thaw cycles, which cause microstructural changes that have an important impact on the structural strength of the loess. These changes in turn affect the stability of structures such as embankments, slopes, and guards. This article takes the Q3 undisturbed loess in Lintong District, Xi’an, as an example. The effects of wetting and freeze‐thaw cycles on the loess expansion ratio and pore structure were studied by wetting tests, freeze‐thaw cycle tests, and scanning electron microscopy (SEM). The changes in the compression index and compression modulus were studied by a confined compression test. The loess e‐lgp compression curve was obtained according to the confined compression test, and the newly defined concepts of the loess structural strength, residual structural strength, and structural strength damage variable, in addition to the e‐lgp compression curve, were combined with the experimental data to calculate the damage value generated by the disturbance during the sampling and preparation of loess. The deterioration of the structural strength and damage variable of loess was analyzed. Based on the microscopic statistical damage theory and Weibull distribution, the model used the volume expansion ratio as a variable to establish a statistical damage model under wetting and freeze‐thaw cycles. Finally, on the basis of the test, the model parameters were determined. The models were verified by taking loess from a foundation pit in the northern suburbs of Xi’an and were in good agreement with the results of the test. Ultimately, the models have good practicability and can provide guidance for engineering design and construction.

2 June 2019 in Geofluids
Verified
Journal Article
Open access
PDF file
HSHaicheng She
Haicheng She
ZHZaiqiang Hu
Zaiqiang Hu
ZQZhan Qu
Zhan Qu
YZYao Zhang
Yao Zhang
HGHu Guo
Hu Guo
In reviewing Chinese shale gas reserves and national policies regarding shale gas exploitation, shale gas will be of critical importance in providing clean natural gas to China. However, compared to those in the United States, the cost of shale gas extraction and the complex problems encountered in more complex and deep drilling in China are key technologies that need to be overcome. Shale wellbore wall instability is a complex problem that often occurs during drilling. During the process of drilling in shale, the complex stress and fluid-structure interactions result in the wall rock generating a strong hydration diffusion and swelling effect, which alters the stress distribution in the rock wall and deteriorates the mechanical parameters of the rock. This results in instability damage of the shale wellbore wall. In this study, the stratigraphic stress characteristics of the Fuling Shale Gas Field were initially predicted, and the shale sample phase composition and development of bedding and microcracks were analyzed using X-ray diffraction and scanning electronic microscopy. The main driving potential difference function between the drilling fluid and shale was analyzed, and a radial adsorption diffusion model of the shale plane was established. Through a laboratory study, the space time change law of the water diffusion of the shale rock was assessed as well as the rock damage evolutionary law of the elastic modulus and compressive strength with water content. Then, combined with the shale hydration stress and strength deformation theory, a damage evolutionary equation for shale with water was derived, and the shale damage evolutionary limit equation and the method of determining the collapse cycle were established. Finally, the method was applied to the Fuling Shale Gas Field, the largest shale gas field in China, and a shale wellbore collapse cycle of approximately seven days in the field was obtained. The severity of economic loss resulting from wellbore wall instability was also determined. This study provides insight and guidance for reducing the costs of shale gas reservoir well drilling and efficient development.

8 June 2023 in Sustainability
Verified
Journal Article
Open access
PDF file
XWXiaoliang Wang
Xiaoliang Wang
LHli hongru
li hongru
YZYue Zhong
Yue Zhong
LZLongfei Zhang
Longfei Zhang
XYXi Yang
Xi Yang
ZHZaiqiang Hu
Zaiqiang Hu
The dry-wet cycle is an important factor that causes slope instability and foundation settlement in loess regions. In order to study the effects of the dry-wet cycle on the structure and shear strength of loess, isotropic compression tests and triaxial shear tests were carried out on loess with different numbers of dry-wet cycles. The results show that the dry-wet cycles mainly reduce the cohesion of loess, and the most obvious decline is after the first cycle; however, they have no effect on the angle of internal friction of loess. The structural yield strength and structural parameters of loess can represent the structure of loess well, which gradually decrease with the increase in the number dry-wet cycles and water content. The initial yield surface is approximately an ellipse, which gradually shrinks with the increase in water content and dry-wet cycles. The structure and cohesion of loess have similar changes, and there is an obvious exponential function relationship between them.

1 January 2021 in Advances in Materials Science and Engineering
Verified
Journal Article
Open access
PDF file
HZHao Zhang
Hao Zhang
ZHZaiqiang Hu
Zaiqiang Hu
XCXingZhou Chen
XingZhou Chen
LHli hongru
li hongru
The existing research data show that, after reservoir impoundment, due to the repeated rise and fall of water level and water‐rock interaction, the mechanical parameters of landslide are reduced, which will have an adverse effect on the stability of landslide. Therefore, sufficient attention must be paid to the stability of slope after reservoir impoundment. Hejia landslide is the largest landslide near the bank of Miaojiaba hydropower station, and its stability plays an important role in the normal operation of the hydropower station. Through field investigation and analysis of regional geological conditions, it is concluded that Hejia landslide is a large‐scale landslide, through long‐term sliding‐bending deformation; it is generated from the external hard rock with thick layers and sliding zone for layered soft rock; the formation mechanism of landslide is as follows: (1) high‐steep and hard‐soft layered slope is the slope structure condition that caused the large landslide; (2) the existence of thick soft rock belt provides material conditions for the formation of slip surface; (3) certain air conditions provide displacement space for the separation and disintegration of the sliding body, and the landslide is stable at present. Numerical analysis results show that reservoir impoundment will adversely affect the stability of landslide. In order to ensure the normal operation of power station, certain engineering measures must be taken to treat Hejia landslide. After taking measures, years of monitoring data show that the deformation of Hejia landslide tends to be stable, and the current operation is normal, indicating that the engineering treatment measures are reasonable and feasible.

26 January 2024 in Bulletin of Engineering Geology and the Environment
Verified
Journal Article
Open access
PDF file
LZLongfei Zhang
Longfei Zhang
ZHZaiqiang Hu
Zaiqiang Hu
HLHongru Li
Hongru Li
HSHaicheng She
Haicheng She
YZYao Zhang
Yao Zhang
XWXiaoliang Wang
Xiaoliang Wang
Loess is a problematic type of soil with a worldwide distribution due to its collapsibility. The temporal discontinuity and spatial nonuniformity of its collapsibility can bring severe damage to building foundations, roads and water pipelines. In this study, the relationship between the saturation and K-G model parameters is established based on indoor compression tests and collapsible tests; the deformation characteristics of loess immersed in water are studied via a large-scale trial immersion pit test. The test site is a circular pit with a diameter of 10 m. The loess is immersed for 46 days; the variation in its accumulated settlement over time is recorded for 60 days, and its deformation process is simulated using a self-designed programme. Results show that for the stress–strain relationship of unsaturated loess, the relationship between equivalent suction and saturation can be obtained through the principle of deformation equivalence and fitted using the exponential function. The maximum vertical displacements calculated in the simulation and on-site immersion pit experiment are 0.036 m and 0.032 m, respectively. Such relatively good consistency indicates that the proposed method can reasonably predict the collapse behaviour of loess due to immersion. This research provides a reliable method for the numerical simulation of loess immersion deformation, and the parameters in the model only need to be determined by conventional experiments.

1 October 2023 in Materials
Verified
Journal Article
Open access
PDF file
XHxiaoning han
xiaoning han
ZHZaiqiang Hu
Zaiqiang Hu
LYLiangshu Yu
Liangshu Yu
YPYuan Pang
Yuan Pang
HSHaicheng She
Haicheng She
CQChangjun Qi
Changjun Qi
To reveal the dynamic characteristics of asphalt core embankment dams (ACEDs), we carried out a dynamic triaxial experiment on hydraulic asphalt concrete (HAC) under different temperatures (T = 4 °C, 10 °C, 16 °C, and 22 °C) and stress states (Kc = 1.0, 1.2, 1.4, and 1.6; σ3 = 0.5, 0.6, 0.7, and 0.8 MPa). The results indicate that HAC’s maximum dynamic elastic modulus increased with decreasing temperature, increasing principal stress ratio, and increasing confining pressure. However, the damping ratio showed the opposite trend. Moreover, in order to study the deformation capacity of HAC, 300 cyclic loads were applied to some specimens. At a temperature of 22 °C, the specimens had a tendency to deform axially, but not significantly. With a decrease in temperature, the axial deformation tendency of the specimen gradually weakened or even disappeared. However, a small number of cracks appeared in the aggregate and between the asphalt and the aggregate of the specimen. In order to quantify the dependence of dynamic parameters on temperature, the temperature influence factor of the maximum dynamic elastic modulus and the temperature sensing factor of the damping ratio were defined. The variation in the temperature influence factor of the maximum dynamic elastic modulus with temperature can be described by a logistic function. The temperature sensing factor of the damping ratio increased with an increasing principal stress ratio and peripheral pressure. Finally, maximum dynamic elastic modulus and damping ratio computational models for the interaction of temperatures and stress states were developed using the normalization method. Upon comparison, the dynamic parameters were observed to be very close to those listed in the literature, which verifies the applicability of the computational models of the maximum dynamic elastic modulus and damping ratio.