As the electromagnetic environment becomes increasingly complex, a synthetic aperture radar (SAR) system with wideband active transmission and reception is vulnerable to interference from devices at the same frequency. SAR interference detection using the transform domain has become a research hotspot in recent years. However, existing transform domain interference detection methods exhibit unsatisfactory performance in complex interference environments. Moreover, most of them rely on label information, while existing publicly available interference datasets are limited. To solve these problems, this paper proposes an SAR unsupervised interference detection model that combines Canny edge detection with vision transformer (CEVIT). Using a time–frequency spectrogram as input, CEVIT realizes interference detection in complex interference environments with multi-interference and multiple types of interference by means of a feature extraction module and a detection head module. To validate the performance of the proposed model, experiments are conducted on airborne SAR interference simulation data and Sentinel-1 real interference data. The experimental results show that, compared with the other object detection models, CEVIT has the best interference detection performance in a complex interference environment, and the key evaluation indexes (e.g., Recall and F1-score) are improved by nearly 20%. The detection results on the real interfered echo data have a Recall that reaches 0.8722 and an F1-score that reaches 0.9115, which are much better than those of the compared methods, and the results also indicate that the proposed model achieves good detection performance with a fast detection speed in complex interference environments, which has certain practical application value in the interference detection problem of the SAR system.

Wind wave-induced artifact surface velocity (WASV) is an important component of the sea surface motions detected by synthetic aperture radar (SAR) systems. Understanding the characteristics of the interference of WASV on SAR current velocity estimates is necessary to improve the accuracy of retrievals. In this study, we assessed and analyzed the sensitivity of WASV in C-band along-track interferometric (ATI) SAR to radar configuration, wind field, swell field, and a wave spectrum model. Results showed that the influence of wind speed on WASV increased with the current velocity. The swell also affected WASV, especially at higher wind speeds; WASV was more strongly influenced by swell amplitude than by swell wavelength. In terms of radar configurations, results showed that VV polarization was more suitable than HH polarization in the estimation of WASV. The interference of WASV was minimal at moderate incidence angles (around 40°), and an appropriate ATI baseline selection was also given. The WASV was more strongly influenced by sea states than by the wave spectrum model or by a spreading function. The findings of this study improve our understanding of WASV and provide a reference for the design of future ATI SAR current measurement instruments and projects.

The primary payload onboard the Gaofen-3-02 (GF3-02) satellite is a C-band Synthetic Aperture Radar (SAR) capable of achieving a maximum resolution of 1 m. This instrument is critical to monitor the marine environment, particularly for tracking sea surface wind speeds, an important marine environmental parameter. In this study, we utilized 192 sets of GF3-02 SAR data, acquired in Quad-Polarization Strip I (QPSI) mode in March 2022, to retrieve sea surface wind speeds. Prior to wind speed retrieval for vertical-vertical (VV) polarization, radiometric calibration accuracy was analyzed, yielding good performance. The results showed a bias and root mean square errors (RMSEs) of 0.02 m/s and 1.36 m/s, respectively, when compared to the European Centre for Medium-Range Weather Forecasts (ECMWF) Reanalysis V5 (ERA5) data. For horizontal–horizontal (HH) polarization, two types of polarization ratio (PR) models were introduced based on the GF3-02 SAR data. Combining these refitted PR models with CMOD5.N, the results for HH polarization exhibited a bias of −0.18 m/s and an RMSE of 1.25 m/s in comparison to the ERA5 data. Regarding vertical–horizontal (VH) polarization, two linear models based on both measured normalized radar cross sections (NRCSs) and denoised NRCSs were developed. The findings indicate that denoising significantly enhances the accuracy of wind speed measurements for VH polarization when dealing with low wind speeds. When compared against buoy data, the wind speed retrieval results demonstrated a bias of 0.23 m/s and an RMSE of 1.77 m/s. Finally, a comparative analysis of the above retrieval results across all three polarizations was conducted to further understand their respective performances.

Global Navigation Satellite System Reflectometry (GNSS-R) is an emerging earth observation method for remote sensing of feature parameters using reflected signals from navigation satellites, and is a purely specular bistatic forward scattering observation means with special right-handed circular polarization incident wave. In this paper, the small-slope approximation model of non-Gaussian sea surface is used as the basis to construct the scattering model for the observation geometry of GNSS-R as well as the L-band characteristics, and the fully-polarization normalized bistatic radar scattering cross section (NBRCS) are simulated by the method of polarization synthesis to analyze the scattering characteristics under different wind speeds and directions on the ocean surface, which highlights the variation of NBRCS with wind direction, and the scattering modeling accuracy is improved by comparing with the data of CYGNSS. In addition, we adopt the observation geometry deviating from purely specular geometry, discuss the scattering azimuth angle, scattering influence, and the relative relationship between different polarizations of the scattering angle under the non-specular geometry.

High-resolution wind vector is important to investigate local winds’ variability over the global ocean. Quad-polarization Synthetic Aperture Radar (SAR) can provide wind vector independently without any external wind direction inputs. Although quad-polarization SAR wind retrieval algorithms have been widely studied, improvements are still required. The amplitude and phase imbalance of polarization channel cannot be neglected for improving the wind vector retrieval precision. In this study, rainforest was performed to remove the amplitude and phase imbalance of polarization channel of GF-3 SAR. To explore the applicability of this method for sea surface measurement, the influence of residual amplitude and phase error for GF-3 quad-polarization SAR on wind vector retrieval was assessed. Variation of amplitude and phase imbalance of sea surface for transmit and receive channel were assessed against collocated wind speed and incidence angle. Considering the polarization difference of VV channel relative to HH channel, the residual amplitude and phase error was found to be closely related to wind speed and polarization isolation. Correction of residual amplitude and phase error were employed to improve the retrieval precision of wind vector. It is revealed that the wind speed retrieval precision of VV polarization improved with correction of residual amplitude error. In addition, the influence of residual amplitude and phase error on wind direction retrieval can be neglected. Thus, it is concluded that correction of amplitude and phase error has the potential to improve wind vector retrievals from GF-3 quad-polarization SAR.