Particulate matter (PM) pollution from coal combustion is a leading contributor to the influence of atmospheric visibility, photochemical smog, and even global climate. A drop tube furnace was employed to explore the effects of temperature and chemical speciation of mineral elements on PM formation during the combustion of Zhundong coal. Chemical fractionation analysis (CFA), X-ray fluorescence (XRF), and inductively coupled plasma-atomic emission spectrometry (ICP-AES) were used to investigate the chemical and physical characteristics of the solid samples. It can be indicated that the combustion of similarly sized coal particles yielded more PM10 when the combustion temperature was increased from 1000 to 1400 °C. Zhundong coal is fractionated with deionized water, ammonium acetate, and hydrochloric acid, and pulverized coal, after fractionation, is burned to study the influence of mineral elements with different occurrence forms, such as water-soluble mineral elements, exchangeable ion elements, hydrochloric acid soluble elements and acid-insoluble elements, on the formation of particles. The results show that water-soluble salts play an important role in forming ultrafine particles (PM0.2); Fe, Ca, and other elements in organic form are distributed in flue gas through evaporation during pulverized coal combustion. When the flue gas temperature decreases, PM1 is formed through homogeneous nucleation and heterogeneous condensation, resulting in the distribution of these two elements on PM1. Different fractionation methods do not significantly affect the distribution of Si and Al in the PM1–10 combustion process.
Wet electrostatic precipitators have problems such as uneven water distribution and poor economy in applying ultra-clean particulate matter emissions from coal-fired boilers. Upgrading the droplets in wet dust removal to charged mobile collectors can effectively compensate for these shortcomings. In this paper, the effects of particle sphericity, particle size, and charge on the capture efficiency of a single droplet for capturing micron and submicron particles are qualitatively studied by simulating the process of particle capture by charged droplets in a turbulent flow field. The simulation results show that the trapping efficiency of charged droplets is positively correlated with the sphericity and the amount of charge. The particle size significantly impacts the capture efficiency, and the increase in size increases the capture efficiency, and the capture efficiency of 5.49 μm particles reaches 100%. The effect of particle movement speed on the capture efficiency needs to be considered in combination with particle size. For micron particles, the capture efficiency is close to 100% when the movement speed is 0.3 m/s and 0.5 m/s. For submicron particles, the aggregation morphology is lower at lower speeds. Simple non-spherical particles have greater capture efficiency.
A natural gas combined cooling, heating, and power (CCHP) system is a typical integrated energy supply method that optimizes end−use energy. However, how to achieve economically feasible natural gas CCHP in severe cold regions with low−grade heat demand reaching 50% is still a pressing issue. This paper establishes a typical natural gas CCHP system model for severe cold regions and conducts the system. Based on the climate conditions of Harbin, the economic optimization of independent gas turbine systems, internal combustion engines, and gas turbine systems is still a pressing issue. Based on the climate conditions of Harbin, the economic optimization of independent gas turbine systems, internal combustion engine systems, and steam boiler systems under different cooling and heating load ratios was carried out. The combination of “internal combustion engine + steam boiler” has the most optimal cost of RMB 1.766 million (USD 0.255 million), saving 10.7%, 7.8%, and 18.3% compared to the three single equipment subsystems respectively. This provides good theoretical support for the construction of multi−energy heterogeneous energy systems.