Piezoelectric materials are defined by their ability to display a charge across their surface in response to mechanical strain, making them great for use in sensing applications. Such applications include pressure sensors, medical devices, energy harvesting and structural health monitoring (SHM). SHM describes the process of using a systematic approach to identify damage in engineering infrastructure. A method of SHM that uses piezoelectric wafers connected directly to the structure has become increasingly popular. An investigation of a novel pitch-catch method of determining instrumentation quality of piezoelectric wafer active sensors (PWASs) used in SHM was conducted as well as an investigation into the effects of defects in piezoelectric sensors and sensor bonding on the sensor response. This pitch-catch method was able to verify defect-less instrumentation quality of pristinely bonded PWASs. Additionally, the pitch-catch method was compared with the electromechanical impedance method in determining defects in piezoelectric sensor instrumentation. Using the pitch-catch method, it was found that defective instrumentation resulted in decreasing amplitude of received and transmitted signals as well as changes in the frequency spectrums of the signals, such as the elimination of high frequency peaks in those with defects in the bonding layer and an increased amplitude of around 600 kHz for a broken PWAS. The electromechanical impedance method concluded that bonding layer defects increase the primary frequency peak’s amplitude and cause a downward frequency shift in both the primary and secondary frequency peaks in the impedance spectrum, while a broken sensor has the primary peak amplitude reduced while shifting upward and nearly eliminating the secondary peak.
Piezoelectric materials, which exhibit a charge distribution across the surfaces in reaction to mechanical strain, find significant utility in actuation and sensing applications. Apart from actuation applications like acoustic devices, motors, and vibration damping, an emerging domain for ultrasonic actuators lies in additive manufacturing processes. Ultrasonic waves applied during solidification aim to modulate grain structure and minimize defects. This research focuses on a fixture designed to facilitate and optimize ultrasonic wave propagation through the build plate in laser powder bed fusion additive manufacturing by utilizing a piezoelectric transducer. Three implementations of piezoelectric transducers were evaluated based on their out-of-plane ultrasonic velocity transmissions. It was determined that a thin plate adhered to the surface of the piezoelectric transducer yielded the most favorable outcomes for implementation, achieving 100% transmission of velocity and energy. Preliminary analysis of melt pool morphology and defects in single-track laser scanning experiments demonstrated the impact of ultrasound on solidification, hinting at a novel approach to enhancing the printability of alloys in laser powder bed fusion additive manufacturing processes. The optimal fixture and the explored transducing efficiency could further guide advanced ultrasound testing to enable in situ defect and texture detection during the additive manufacturing processes.