The traditional blade cooling method can no longer meet the requirements of high cooling efficiency in modern engines. In order to solve this cooling problem, this paper proposes cooling turbine guide blades based on liquid metal. The feasibility was preliminarily verified using a one-dimensional heat conduction model. Then, using a numerical method, we found that the cooling effect of liquid metal is much better than that of air cooling. The main reason for its good cooling effect is that the heat transfer coefficient of liquid metal reaches a magnitude of tens of thousands. Moreover, as the inlet temperature of the liquid metal decreases and the inlet Reynolds number increases, the liquid cooling effect becomes better. The definition of the heat transfer quality factor can reflect the reasons for the influence of the inlet temperature of the liquid metal.
1 August 2026 in Journal of Physics: Conference Series
This work numerically investigates the effects of the vortex reducer tube length and the drum hole geometry on the pressure loss, windage torque, and flow structure in a compressor disk cavity, with the aim of enhancing the secondary air system efficiency. The computational results reveal that, at a given flow coefficient, increasing the rotational Reynolds number (
Re
θ = ρωR2 / μ ) reduces both the static pressure loss coefficient (
C
p = Δ P /0.5 ρω2R2 ) and the torque coefficient (
C
m = M /0.5 ρω2R5 ). At high rotational speeds, the growth rate of the pressure drop Δ P with rotational speed is large, while that of the torque M is small. At low rotational speeds, the growth rate of Δ P becomes smaller, whereas that of M becomes larger. The size of the obround drum holes significantly affects the pressure and windage losses, while the influence of the vortex reducer tube length is relatively weak. Enlarging the drum hole size can effectively reduce
C
p and
C
m . Furthermore, distinct optimal tube lengths are identified for minimizing
C
p and
C
m respectively, providing design guidelines for lightweight, high-performance rotating structures.