Thermoelectric effect is studied in an Aharonov-Bohm interferometer with an embedded quantum dot (QD) in the Coulomb blockade regime. The electrical conductance, electron thermal conductance, thermopower, and thermoelectric figure-of-merit are calculated by using the Keldysh Green's function method. It is found that the figure-of-merit ZT of the QD ring may be quite high due to the Fano effect originated from the quantum interference effect. Moreover, the thermoelectric efficiency is sensitive to the magnitude of the dot-lead and inter-lead coupling strengthes. The effect of intradot Coulomb repulsion on ZT is significant in the weak-coupling regime, and then large ZT values can be obtained at rather high temperature.
Holographic data storage (HDS) has emerged as a promising technology for high-capacity data storage. In this study, we propose a novel approach to enhance the storage density in HDS through a multiplexing perfect optical vortex (POV) hologram. By utilizing the orthogonality property of POV, different POV-recording holograms can be multiplexed to store multiple data pages within the single hologram. Compared with the conventional optical vortex, the better storage density of POV through proof-of-principle experiments is demonstrated. For the POV-multiplexing hologram of six data pages, each one can be reconstructed successfully. In addition, we investigate the impact of axicon periods and multiplexing numbers on the storage performance. Our results reveal that an appropriate selection of axicon periods and multiplexing numbers is crucial to balance storage density and bit error rate (BER). The proposed multiplexing approach offers a valuable solution for achieving high-density and secure holographic data storage systems.
1 July 2019 in Solar Energy Materials and Solar Cells
Operating temperature is a key factor affecting the output power of a crystalline silicon solar cell (c-Si SC). Based on solving basic semiconductor equations, Maxwell equations and heat flow equations by finite difference method, this work has theoretically investigated the influences of microfluidic cooling system on the temperature distributions and output parameters of an industrial c-Si SC packaged as a module form, where the cooling system is installed the interface between the aluminum electrode and back ethylene vinyl acetate layer and the cooling medium flowing through microchannel is selected as water. Under the influences of the cooling system, the back surface temperature of the c-Si SC is fixed at about water temperature and the front surface temperature will decrease with the water temperature decreasing. The temperature distributions of c-Si active layer and aluminum layer decrease approximately linearly along the two layer’s thickness directions. The cooling effects of the cooling system are mainly determined by water temperature and when the filling factor of microchannel is larger than 0.1, its influences on the temperature distribution of the c-Si SC are small. In the environmental temperature range from −15 °C to 60 °C, the increase rates of Voc, FF and η per degree Celsius with the water temperature decreasing are about 0.0014 V, 0.036% and 0.05%, respectively.
The accurate measurement of the output parameters of photovoltaic (PV) cells is a key step in building a PV system. The output parameters of a PV cell under actual test conditions will appear different degrees of the deviation from those under the standard test conditions. In this work, we are primarily concerned with the deviations of the temperature distributions and output parameters of a testing c-Si solar cell caused by the heat transfer process under actual test conditions. The results show that the temperature distributions of c-Si solar cells under actual test conditions will be uneven and obviously deviate from those under the standard test conditions; the heat transfer coefficients at the interfaces between the front surface and environmental air and between the back surface and mental holder have important consequences for the temperature distributions of c-Si solar cells; under the actual test conditions of PV enterprises, the possible deviation range of short-circuit current density, open-circuit voltage, filling factor, and efficiency may be from −17 to 9 µA/cm2, from −11 to 17 mV, from −0.4% to 0.7%, and from −0.4% to 0.7%, respectively.