The proper pattern of electric energy management on the part of consumers is a key element of the system enabling its effective use. This pattern can be developed by providing consumers with information obtained from non-invasive load monitoring. Improvement electric energy management can be achieved by turning off unnecessary appliances and by shifting some of them to off-peak hours. A rational benefit for consumers is the reduction of electricity consumption costs. In this paper, energy disaggregation was abandoned by introducing virtual electrical devices and by using optimal selection of explanatory data obtained from high-frequency measurements. The concept of virtuality results from the simultaneous operation of many physical devices, and especially for which it is difficult to distinguish the state of load, e.g. small, medium or large. The explanatory data was selected using the integral information capacity indicator of individual features. The determination of this indicator is based on the correlations between the explanatory variables, the explained variable and the mutual correlations between the explanatory variables. The parameters selected in this way constitute input data for various artificial neural network architectures identifying the electrical appliances. The obtained research results are very promising and confirm the validity of the approach used.
The present paper covers a review of documents that specify measurement methods of voltage waveform distortion. It also presents measurement stages of waveform components that are uncommon in the classic fundamentals of electrotechnics and signal theory, including the creation process of groups and subgroups of harmonics and interharmonics. Moreover, the paper discusses selected distortion factors of periodic waveforms and presents analyses that compare the values of these distortion indices. The measurements were carried out in the cycle per cycle mode and the measurement methodology that was used complies with the IEC 61000-4-7 norm. The studies showed significant discrepancies between the values of analyzed parameters.
The paper discussed the studies related to the output voltage distortion of frequency inverter depending on its frequency. The changes in the effective value of voltage, THD, harmonics and interharmonics were presented for three different frequencies, lower than 50Hz. Additionally, it was shown how these values change depending on measurement time, presenting waveforms cycle by cycle in graphs, averaged in 10 periods and averaged in 150 periods of the analyzed signal. The studies were conducted in the laboratory area equipped with power quality meter class A.
28 April 2011 in International Journal of Numerical Modelling: Electronic Networks, Devices and Fields
The article concerns the issues related to the concept of power in a description of the non-linear receiver. The definitions of signals given in the applicable standards (norms) were used and the analysis of samples received from active experiments was carried out. A set of a drive system consisting of a thyristor converter and a DC motor was examined. The Elspec Blackbox G4500 energy quality analyzer was used for the measurements. The results were compiled in the form of many graphs in the time and frequency form. The analysis shows that during unloaded operation, undesirable power is mainly absorbed (passive and current distortions), while the active power is pulsating. It is noted that the nonlinearity of the receiver causes deterioration of the system's power.
This article concern to systems that support the manage economical use of electricity. An advisory and monitoring system equipped with artificial intelligence for non-invasive on-line identification of electrical devices was proposed. Research has been done on the basic element of the system, which is the classifier module. As data describing the objects, the electrical quantities obtained from the Elspec BlackBox 4500 analyzer were used. It implements the various configurations of artificial neural networks (ANN), to provide identification efficiency of 68%-91%. The advantages of the various classifiers due to their architecture ware pointed out.