Highly transparent Ho:Y₂O₃ ceramics for laser diode lighting were prepared using the vacuum sintering method with 0.3 at.% Nb₂O₅ as a sintering additive. The microstructures, transmittance, and luminescence properties of the Ho:Y₂O₃ ceramic samples were investigated in detail. The transmittance levels of all samples with various Ho³⁺ concentrations reached ~81.5% (2 mm thick) at 1100 nm. Under the excitation of 363 nm (ultraviolet) or 448 nm (blue) light, Ho:Y₂O₃ transparent ceramic samples showed that green emission peaked at 550 nm. The emission intensity was strongly affected by the concentration of Ho³⁺ ions, reaching its highest level in the sample doped with 1 at.% Ho³⁺. The CIE coordinates of the luminescence were in the green region (i.e., the CIE coordinates of the sample doped with 1 at.% Ho³⁺ were [0.27, 0.53] and [0.30, 0.69], under the excitation of 363 nm and 448 nm light, respectively). The possibility of its application as laser diode lighting was reported. Under the excitation of 450 nm blue laser, the sample doped with 0.5 at.% Ho³⁺ had the best performance: the saturated luminous flux, lumen efficiency, and the luminescence saturation power densities were 800 lm, 57.7 lm/W, and 17.6 W/mm², respectively. Furthermore, the materials have high thermal conductivity and mechanical strength due to their host of rare-earth sesquioxide. Thus, Ho:Y₂O₃ transparent ceramics are expected to be a promising candidate for green-light-emitting devices for solid-state lighting, such as laser diode lighting.

Highly transparent Er:Y₂O₃ ceramics (1–9 at.% Er) were fabricated by hot pressing sintering with ZrO₂ as the sintering additive. The microstructures, transmittance, luminescent properties, thermal conductivity, and mechanical properties of the Er:Y₂O₃ ceramic samples were investigated in detail. The samples all exhibited dense and fine grain microstructures; the average grain sizes were about 0.8 μm. The transmittance levels of the samples with various Er concentrations (2 mm thick) at the wavelengths of 600 and 2700 nm were ~74 and ~83%, respectively. As the Er doping concentration increased from 1 to 9 at.%, the up-conversion luminescence of the samples gradually changed from green to red, with the intensity ratio of red/green light increasing from 0.28 to 2.01. Meanwhile, the down-conversion luminescence properties of the specimens were also studied. When the samples were under 980 nm excitation, the emission bands were detected at 1552, 1573, 1639, and 1661 nm. The thermal conductivity of the samples was found to decrease from 8.72 to 5.81 W/(m·K) with an increase of the Er concentration from 1 to 9 at.%. Moreover, the microhardness and fracture toughness of the samples with 1 at.% Er concentration were ~8.51 GPa and ~1.03 MPa·m^1/2, respectively.