The mechanical properties of various Ti-6Al-4V alloys are influenced by their respective microstructures. This study generated an ultrafine-grain (UFG) Ti-6Al-4V alloy featuring bimodal grain distribution characteristics achieved through initial heat treatment, multi-axial forging (MF), and annealing. The study also extensively examined the evolution process of the alloy’s microstructure. By subjecting the materials to heat treatments at 900 °C with air cooling and 950 °C with air cooling, both materials were found to be consisted of primary α (αp) and transformed β (αs+β) regions with different proportions. Following MF, the sample treated at 900 °C displays a microstructure featuring UFGs of α+β surrounding larger micron-sized αp grains. On the other hand, the sample treated at 950 °C displays a microstructure distinguished by twisted αs lamellar and fragmented β grains surrounding larger micron-sized αp grains. Following annealing, no significant grain growth was observed in the sample. The geometrically necessary dislocations (GNDs) within the UFGs were eliminated, though some GNDs persisted within the αp grains. The samples undergoing the 900 °C heat treatment, MF, and subsequent annealing exhibited elevated strength (1280 MPa) and total elongation (10.7%). This investigation introduces a novel method for designing the microstructure of the Ti-6Al-4V alloy to achieve superior performance.
25 December 2023 in Journal of Materials Research and Technology
Microstructure is a significant factor that influences the mechanical properties of alloys. The effect of multiaxial forging (MAF) and subsequent aging treatment on the precipitated phases of Al-Zn-Mg-Cu alloy remains unclear. Therefore, an Al-Zn-Mg-Cu alloy was processed by means of solid solution and aging treatment, and MAF and aging treatment in this work, and the composition and distribution of precipitated phases were characterized in detail. The MAF results for dislocation multiplication and grain refinement were found. The high density of dislocation greatly accelerates the nucleation and growth of precipitated phases. Thus, the GP-zones almost transform into precipitated phases during subsequent aging. The MAF and aging alloy has more precipitated phases than the solid solution and aging treated alloy. The precipitates on the grain boundary are coarse and discontinuously distributed due to dislocation and grain boundary promoting the nucleation, growth and coarsening of the precipitates. The hardness, strength, ductility and microstructures of the alloy have been studied. Without compromising the ductility much, the MAF and aging alloy has higher hardness and strength, with values of 202 HV and 606 MPa, respectively, and an appreciable ductility of 16.2%.
To address the challenge of controlling Fe impurity content during the recycling of aluminum alloys, this study utilized commercial 5083 aluminum alloy as a matrix to prepare alloy samples with four different Fe contents via smelting. The effects of Fe content on the microstructure, mechanical properties, and corrosion resistance of the as-cast 5083 aluminum alloy were systematically investigated. The results indicate that increasing the Fe content induces a significant morphological evolution of the Fe-rich phases, transitioning from compact Chinese-script α-Al(Fe,Mn)Si phases at low Fe levels to coarse needle-like β-AlFeSi phases. Concurrently, both the quantity and size of the second phases increase significantly. Mechanical testing reveals that the hardness of the alloy gradually rises from 67 HV to 72 HV due to second-phase strengthening. The tensile strength shows a trend of initially increasing and then decreasing, peaking at 0.45 wt.% Fe; however, excessive Fe leads to the formation of needle-like phases that cause stress concentration, resulting in a decline in tensile strength. The elongation decreases gradually with increasing Fe content, with a maximum reduction of 19.7%. Electrochemical tests show that higher Fe content increases the self-corrosion current density and decreases the capacitive loop radius, indicating a significant degradation in the alloy’s corrosion resistance. This work provides an experimental basis for the tolerance control of Fe impurities and the performance optimization of recycled 5083 aluminum alloys.