We experimentally demonstrate Si-based electrolyte-gated transistors (EGTs) for detecting urea. The top-down-fabricated device exhibited excellent intrinsic characteristics, including a low subthreshold swing (SS) (~80 mV/dec) and a high on/off current ratio (~10⁷). The sensitivity, which varied depending on the operation regime, was analyzed with the urea concentrations ranging from 0.1 to 316 mM. The current-related response could be enhanced by reducing the SS of the devices, whereas the voltage-related response remained relatively constant. The urea sensitivity in the subthreshold regime was as high as 1.9 dec/pUrea, four times higher than the reported value. The extracted power consumption of 0.3 nW was extremely low compared to other FET-type sensors.

The sensing responses of SARS-CoV-2 spike protein using top-down-fabricated Si-based electrolyte-gated transistors (EGTs) have been investigated. An aptamer was employed as a receptor for the SARS-CoV-2 spike protein. The EGT demonstrated excellent intrinsic characteristics and higher sensitivity in the subthreshold regime compared to the linear regime. The limit of detection (LOD) was achieved as low as 0.94 pg/mL and 20 pg/mL for the current and voltage sensitivity, respectively. To analyze the sensing responses of EGT in detecting the aptamer–SARS-CoV-2 spike protein conjugate, a lumped-capacitive model with the presence of an effective dipole potential and an effective capacitance of the functionalized layer component was employed. The aptamer-functionalized EGT showed high sensitivity even in 10 mM phosphate-buffered saline (PBS) solution. These results suggest that Si-based EGTs are a highly promising method for detecting SARS-CoV-2 spike proteins.

Silver nanowire (AgNW) coating was applied to the gate surface of silicon-based electrolyte-gated transistors (EGTs) by spray coating and lift-off patterning to enhance biosensing performance. The intrinsic electrical properties of the device remained largely unaffected following AgNW deposition. After aptamer immobilization, threshold voltage variations were observed across different AgNW coating durations, indicating that the AgNW layer facilitates increased receptor density and improved sensitivity. The lumped-capacitive model was employed to calculate the dipolar and capacitive contributions. In the detection of Chikungunya virus (CHIKV), the AgNW-coated EGT (EGT-AgNW) demonstrated a 230% increase in sensitivity and achieved a limit of detection (LOD) as low as 430 pg/mL, approximately 200× lower than that of uncoated conventional EGTs. Furthermore, the sensor showed high selectivity against other mosquito-borne tropical viruses, such as dengue, Zika, and yellow fever (YF). These results indicate the potential of EGT-AgNW as low-cost, high-performance biosensing platforms capable of detecting CHIKV and other biomarkers at ultralow concentrations.

Multiplexed detection of arboviruses using a 4 × 4 Si-based electrolyte-gated transistor (EGT) array functionalized with specific aptamers has been investigated. The Si-based EGTs were fabricated using conventional Si microfabrication processes. The EGTs showed excellent intrinsic electrical characteristics, including a low threshold voltage of 0.8 V, a sub-threshold swing of 75 mV/dec, and a gate leakage of <10 pA, ensuring uniform device performance with low device-to-device variation. Aptamers specific to the yellow fever virus nonstructural protein 1 (YF), dengue virus nonstructural protein 1 (DN), and chikungunya virus envelope protein 2 (CHK) were functionalized on EGT arrays to evaluate individual and multiplexed detection. In individual-target detections, concentration-dependent negative shifts in threshold voltage were observed, and relevant limits of detection (LOD) as low as 38.6 pg/mL, 95.2 pg/mL, and 1.6 ng/mL were extracted for YF, DN, and CHK, respectively. In multiplexed detections, sensitivities decreased and variations increased relative to the individual responses, resulting in higher LODs. The extracted LODs were 0.2 ng/mL, 0.6 ng/mL, and 2.8 ng/mL for YF, DN, and CHK, respectively, which are lower than those reported for other methods. These results suggest that Si-based EGT arrays are promising as a scalable, low-cost, and highly sensitive biosensing platform for multiplexed arbovirus detection and point-of-care diagnostics.

We investigated the impact of surface treatments on Si-based electrolyte-gated transistors (EGTs) for detecting urea. Three types of EGTs were fabricated with distinct gate electrodes (Ag, Au, Pt) using a top-down method. These EGTs exhibited exceptional intrinsic electrical properties, including a low subthreshold swing of 80 mV/dec, a high on/off current ratio of 10⁶, and negligible hysteresis. Three surface treatment methods ((3-amino-propyl) triethoxysilane (APTES) and glutaraldehyde (GA), 11-mercaptoundecanoic acid (11-MUA), 3-mercaptopropionic acid (3-MPA)) were individually applied to the EGTs with different gate electrodes (Ag, Au, Pt). Gold nanoparticle binding tests were performed to validate the surface functionalization. We compared their detection performance of urea and found that APTES and GA exhibited the most superior detection characteristics, followed by 11-MUA and 3-MPA, regardless of the gate metal. APTES and GA, with the highest pKa among the three surface treatment methods, did not compromise the activity of urease, making it the most suitable surface treatment method for urea sensing.