This article proposes a non-contacting measurement technique based on acoustic monitoring to detect cracks or damage within a structure by observing sound radiation using a single microphone or a beamforming array. The technique works by mounting an audio speaker inside a hollow structure, such as a wind turbine blade, and observing the sound radiated from the blade to identify damage. The primary hypothesis for this structural damage detection technique is that the structural damage (cracks, edge splits, holes, etc.) on the surface results in changes in the sound radiation characteristics of the structure. Preliminary measurements to validate the methodology were carried out on a section of a wind turbine blade containing different sized holes and cracks. An acoustic microphone array with 62 microphones was used to measure the sound radiated from the structure when an audio speaker generating random noise was placed inside a cavity emulating a wind turbine blade. A phased array beamforming technique and CLEAN-based subtraction of point spread function from a reference were employed to locate the different damage types on the test structures. The same experiment was repeated using a commercially available 48-channel acoustic ring array to compare the test results. It was shown that both the acoustic beamforming and the CLEAN-based subtraction of point spread function from reference techniques can identify the damage in the test structures with sufficiently high fidelity.
7 April 2016 in Journal of Vibration and Acoustics
The three-dimensional point-tracking (3DPT) measurement approach is used in conjunction with finite element (FE) method and modal expansion technique to predict full-field dynamic response on a rotating structure. A rotating three-bladed wind turbine rotor was subjected to different loading scenarios, and the displacement of optical targets located on the blades was measured using 3DPT. The out-of-plane measured displacement of the targets was expanded and applied to the FE model of the turbine to extract full-field strain on the turbine. The sensitivity of the proposed approach to the number of optical targets was also studied in this paper. The results show that the dynamic strain on a structure can be extracted with a very limited set of measurement points (optical targets) placed on appropriate locations on the blades. It was shown that the proposed technique is able to extract dynamic strain all over the entire structure, even inside the structure beyond the line of sight of the measurement system. Because the method is based on a noncontacting measurement approach, it can be readily applied to a variety of structures having different boundary conditions.