The research presented in this article focuses on a 9-m CX-100 wind turbine blade, designed by a team led by Sandia National Laboratories and manufactured by TPI Composites Inc. The key difference between the 9-m blade and baseline CX-100 blades is that this blade contains fabric wave defects of controlled geometry inserted at specified locations along the blade length. The defect blade was tested at the National Wind Technology Center at the National Renewable Energy Laboratory using a schedule of cycles at increasing load level until failure was detected. Researchers used digital image correlation, shearography, acoustic emission, fiber-optic strain sensing, thermal imaging, and piezoelectric sensing as structural health monitoring techniques. This article provides a comparison of the sensing results of these different structural health monitoring approaches to detect the defects and track the resultant damage from the initial fatigue cycle to final failure.
The three-dimensional point-tracking (3DPT) measurement approach is used in conjunction with finite element (FE) method and modal expansion technique to predict full-field dynamic response on a rotating structure. A rotating three-bladed wind turbine rotor was subjected to different loading scenarios, and the displacement of optical targets located on the blades was measured using 3DPT. The out-of-plane measured displacement of the targets was expanded and applied to the FE model of the turbine to extract full-field strain on the turbine. The sensitivity of the proposed approach to the number of optical targets was also studied in this paper. The results show that the dynamic strain on a structure can be extracted with a very limited set of measurement points (optical targets) placed on appropriate locations on the blades. It was shown that the proposed technique is able to extract dynamic strain all over the entire structure, even inside the structure beyond the line of sight of the measurement system. Because the method is based on a noncontacting measurement approach, it can be readily applied to a variety of structures having different boundary conditions.