In view of the increasing number of space objects, comprehensive high‐quality space surveillance becomes ever more important. Radar is a powerful tool that, in addition to detection and tracking of objects, also enables spatially high‐resolution imaging independent of daylight and most weather conditions. Together with the technique of Inverse Synthetic Aperture Radar (ISAR), very high‐resolution and distance‐independent two‐dimensional images can be obtained. However, advanced high‐performance radar imaging of space objects is a complex and demanding task, touching many technological and signal processing issues. Therefore, besides theoretical work, the Microwaves and Radar Institute of German Aerospace Center (DLR) has developed and constructed an experimental radar system called IoSiS (Imaging of Satellites in Space) for basic research on new concepts for the acquisition of advanced high‐resolution radar image products of objects in a low earth orbit. Based on pulse radar technology, which enables precise calibration and error correction, IoSiS has imaged space objects with a spatial resolution in the centimetre range, being novel in public perception and accessible literature. The goal of this paper is therefore to communicate and illustrate comprehensively the technological steps for the construction and successful operation of advanced radar‐based space surveillance. Besides the basic description of the IoSiS system design this paper outlines primarily useful theory for ISAR imaging of objects in space, together with relevant imaging parameters and main formulae. All relevant processing steps, necessary for very high‐resolution imaging of satellites in practice, are introduced and verified by simulation results. Finally, a unique measurement result demonstrates the practicability of the introduced processing steps and error correction strategies.
With the number of new satellites increasing dramatically, comprehensive space surveillance is becoming increasingly important. Therefore, high-resolution inverse synthetic aperture radar (ISAR) imaging of satellites can provide an in-situ assessment of the satellites. This paper demonstrates that pseudo-noise signals can also be used for satellite imaging, in addition to classical linear frequency-modulated chirp signals. Pseudo-noise transmission signals offer the advantage of very low cross-correlation values. This, for instance, enables the possibility of a system with multiple channels transmitting instantaneously. Furthermore, it can significantly reduce signal interference with other systems operating in the same frequency spectrum, which is of particular interest for high-bandwidth, high-power systems such as satellite imaging radars. A new routine has been introduced to generate a wideband pseudo-noise signal with a peak-to-average power ratio (PAPR) similar to that of a chirp signal. This is essential for applications where the transmit signal power budget is sharply limited by the high-power amplifier. The paper presents both theoretical descriptions and analysis of the generated pseudo-noise signal as well as the results of an imaging measurement of a real space target using the introduced pseudo-noise signals.
Many countries face the problem of land mines and unexploded ordnance contaminated land sections which present a significant risk to the civilian population. The detection and subsequent clearance of these explosive hazardous substances is therefore extremely important and necessary. Ground penetrating radar (GPR) is a suitable tool and is considered as a complementing sensor since nearly two decades. However, most GPRs operate in very close distance to ground in a rather punctual method of operation. In contrast, synthetic aperture radar (SAR) is a technique allowing fast and laminar stand-off investigation of an area. In this paper the final radar hardware setup and first railway based measurements are described.
15 January 2026 in IEEE Transactions on Radar Systems
High-resolution multistatic imaging radar systems pose significant challenges to the employed synchronization schemes, as such radar networks need to operate coherently. Especially high-resolution systems operating at a high center frequency push the required synchronization requirements into the single-digit picosecond regime. Within the project Imaging of Satellites in Space—Next Generation (IoSiS-NG), the task at hand is further challenged by the use of far baselines, where commonly seen approaches fail, as no line-of-sight (LOS) free-space propagation or wired method can be employed. In this article, a robust synchronization method is presented that elevates well-established global navigation satellite systems (GNSSs)-based methods by about three orders of magnitude through the coordinated reception of non-cooperative (NC) signals at all participating nodes. Exploiting the identical signal payload at all stations, the timing and phase differences of the nodes can be tracked and corrected in the post-processing stage. Here, we demonstrate our newly developed algorithm, simulative studies and real-world experiments using satellite broadcast television (TV) signals as NC signals to synchronize a high-resolution imaging radar achieving a timing standard deviation of less than 1.8 ps and a phase coherence for the X-band radar of less than 2° allowing interferometric or tomographic imaging principles to be used.
As the need for new and advanced space situational awareness systems increases, new technologies for in situ observations are needed. The experimental IoSiS (Imaging of Satellites in Space) system at the German Aerospace Center (DLR) is already capable of high-resolution imaging tasks using inverse synthetic aperture radar technology. As two-dimensional radar images can be difficult to interpret, full three-dimensional imaging is desired. This paper extends the previously published simulation aspects to real ground-based experiments using a single spatially separated receiver, allowing interferometric measurements. However, as interferometry cannot fully resolve a three-dimensional object, more spatially separated receivers are also considered for the use of ISAR tomography to gain experimental insight into true three-dimensional imaging as IoSiS will eventually move toward a tomographic acquisition mode. The results shown here promise a high-resolution imaging method for the future development of IoSiS. Based on the research presented here, additional receivers can be implemented into IoSiS to establish real-world three-dimensional measurements of space objects.