High-resolution multistatic imaging radar systems pose significant challenges to the employed synchronization schemes, as such radar networks need to operate coherently. Especially high-resolution systems operating at a high center frequency push the required synchronization requirements into the single-digit picosecond regime. Within the project Imaging of Satellites in Space—Next Generation (IoSiS-NG), the task at hand is further challenged by the use of far baselines, where commonly seen approaches fail, as no line-of-sight (LOS) free-space propagation or wired method can be employed. In this article, a robust synchronization method is presented that elevates well-established global navigation satellite systems (GNSSs)-based methods by about three orders of magnitude through the coordinated reception of non-cooperative (NC) signals at all participating nodes. Exploiting the identical signal payload at all stations, the timing and phase differences of the nodes can be tracked and corrected in the post-processing stage. Here, we demonstrate our newly developed algorithm, simulative studies and real-world experiments using satellite broadcast television (TV) signals as NC signals to synchronize a high-resolution imaging radar achieving a timing standard deviation of less than 1.8 ps and a phase coherence for the X-band radar of less than 2° allowing interferometric or tomographic imaging principles to be used.
As the need for new and advanced space situational awareness systems increases, new technologies for in situ observations are needed. The experimental IoSiS (Imaging of Satellites in Space) system at the German Aerospace Center (DLR) is already capable of high-resolution imaging tasks using inverse synthetic aperture radar technology. As two-dimensional radar images can be difficult to interpret, full three-dimensional imaging is desired. This paper extends the previously published simulation aspects to real ground-based experiments using a single spatially separated receiver, allowing interferometric measurements. However, as interferometry cannot fully resolve a three-dimensional object, more spatially separated receivers are also considered for the use of ISAR tomography to gain experimental insight into true three-dimensional imaging as IoSiS will eventually move toward a tomographic acquisition mode. The results shown here promise a high-resolution imaging method for the future development of IoSiS. Based on the research presented here, additional receivers can be implemented into IoSiS to establish real-world three-dimensional measurements of space objects.